Abstract:One of the most widely employed methods for adsorption is the utilization of biochar produced during pyrolysis. Biochar has attracted considerable attention due to its oxygen-containing functional groups and relatively high specific surface area. In alignment with the principles of cleaner production, the sludge generated from sewage treatment plants is typically classified as waste. However, it can be effectively repurposed as an adsorbent following pyrolysis and subsequent nanoparticle modification. This environmentally friendly approach presents an ecological alternative to conventional water treatment methods. The objective of this study is to evaluate the efficiency of batch adsorption for the removal of phosphate from wastewater using both unmodified and modified sewage sludge biochars (SSBs) that were produced at various temperatures (300 °C, 400 °C, 500 °C, and 600 °C) and modified with zero-valent iron nanoparticles (nZVI-SSB300, nZVI-SSB400, nZVI-SSB500, and nZVI-SSB600). The findings indicate that biochar modified with functional nanoparticles is a highly effective adsorbent for the removal of phosphate from wastewater. As demonstrated by the research results, the adsorption capacity of modified biochar is approximately 3 to 3.5 times greater than that of the unmodified variants. The phosphate removal efficiency with modified biochars was optimal with nZVI-SSB600. In experiments with a phosphate concentration (25 mg/L), the modified sorbent biochar exhibited an equilibrium adsorption capacity of 23.74 mg/g, translating to a phosphate removal efficiency of 60%. Under similar test conditions, at an initial phosphate concentration of 50 mg/L, the adsorption capacity improved to 25.67 mg/g (75% efficiency); at 75 mg/L, it reached 27.97 mg/g (80%); at 100 mg/L, it was 28.44 mg/g (85%); and at 125 mg/L, it achieved 29.48 mg/g (89%). The models confirmed the observed adsorption behavior, yielding a maximum phosphate adsorption capacity (qe) of 19.00 mg/g for the 600 °C pyrolysis of modified biochar at the primary phosphate concentration (25 mg/L). Furthermore, this study indicates that the influence of solution pH on phosphate adsorption remains stable and maximal (nZVI-SSB600, ranging from 16.87 to 20.46 mg/g) within the pH range of 3 to 8. On average, the modified biochar (nZVI-SSB) demonstrated 20 to 30% superior adsorption performance compared to the unmodified biochar (SSB). Additionally, significant differences were noted between various ambient temperatures, ranging from 5 °C to 25 °C. As the ambient temperature increased, the sorption capacity of the adsorbent exhibited a considerable improvement. With a primary concentration of phosphate (100 mg/g) at 5 °C, the adsorption capacity of nZVI-SSB600 was measured at 7.99 mg/g; this increased to 14.33 mg/g at 10 °C, 21.79 mg/g at 20 °C, and 28.44 mg/g at 25 °C. This research highlights the potential application of biochar in wastewater treatment for phosphate removal, simultaneously enabling the effective utilization of generated sewage sludge waste through pyrolysis and coating with zero-iron nanoparticles, resulting in a sustainable solution.

Efficient removal of phosphate from aqueous solution by burnt brick clay: static conditions

Synthesis of Al-Modified Hydrochar from Corn Stover for Efficient Phosphate Removal

Zirconium-modified biochar as the efficient adsorbent for low-concentration phosphate: performance and mechanism

Adsorptive removal of phosphate from water with biochar from acacia tree modified with iron and magnesium oxides

Removal of phosphate from synthetic wastewater: A comparative study between both activated clays using an experimental design methodology

Phosphate removal from aqueous solution using calcium-rich biochar prepared by the pyrolysis of crab shells

Efficient Removal of Phosphate through Adsorption by Acidified Diatomite Loaded with La2O2CO3

Kinetics, Isotherms, and Thermodynamic Modeling of the Adsorption of Phosphates from Model Wastewater Using Recycled Brick Waste

Removal of phosphate from wastewater using coal slag

Evaluation of potential adsorbents for simultaneous adsorption of phosphate and ammonium at low concentrations

Removing Phosphates from Aqueous Solutions by Means of Static Sorption on Ash-and-Slag Sorbent: Analyzing Coefficients of Distribution Based on Adsorption Isotherms

Phosphate Removal Mechanisms in Aqueous Solutions by Three Different Fe-Modified Biochars

Equilibrium and Kinetics Studies of Phosphate Removal from Solution Onto a Hydrothermally Modified Al-Si-Fe-Ca Composite Adsorbent

Heated Kaolinite-La(iii) Hydroxide Complex for Effective Removal of Phosphate from Eutrophic Water

Phosphate adsorption from natural waters and evaluation of sediment capping using modified clays

Kinetics, Isotherms and Adsorption–Desorption Behavior of Phosphorus from Aqueous Solution Using Zirconium–Iron and Iron Modified Biosolid Biochars

An Investigation of the Batch Adsorption Capacity for the Removal of Phosphate from Wastewater Using Both Unmodified and Functional Nanoparticle-Modified Biochars

Removal of Phosphate from Water by a Fe–Mn Binary Oxide Adsorbent

Molecular insights and thermodynamic feasibility of phosphate adsorption on Ca-biocomposites using a simplified carbon structure

Removal of Phosphate from Aqueous Solution Using Magnesium-Alginate/Chitosan Modified Biochar Microspheres Derived from Thalia Dealbata

Removal of Phosphate from Wastewater by Lanthanum Modified Bio-Ceramisite