Abstract:Heat exchangers play a major role in reducing emissions and conserving energy. There is a plethora of theoretical research on the enhancement of heat transfer caused by ionic wind, but there is still a lack of studies on the practical application of ionic wind in heat exchangers to increase heat exchange capacity. This work developed an original ionic wind heat exchanger with a dividing wall. It may be applied to difficult circumstances when conventional heat exchangers fail for air-to-air heat exchange. The study conducted experiments to investigate the impact of many factors, including intake air velocity, discharge spacing, and electrode distribution scheme, on the ionic wind intensity and the heat exchanger's increased heat transfer coefficient. A two-dimensional model was used to analyze the internal flow and thermal properties of the heat exchangers with wire emitters. By combining active and passive heat exchange technologies, an ionic wind heat exchanger with serrated grounded electrodes was presented. The outcomes demonstrated that a suitable intake air velocity enhances the heat exchanger's capacity for heat exchange. The improved heat exchange effect of ionic wind is more important when the inlet wind speed is less than 1 m/s. When the intake air velocity approaches 1.3 m/s, the ionic wind has less of an impact on the heat exchanger's capacity for heat exchange. The benefits of improved heat transfer are promoted by placing the emitter closer to the channel entry. Increasing the operating voltage further enhances the heat transfer enhancement ratio (HTER). The number and arrangement of wire electrodes should be chosen with consideration for the 'barrier effect' between neighboring emitters and the distance from the entrance when utilizing multiple wire electrodes. In comparison to the three-wire and five-wire electrodes, the four-wire electrode heat exchanger's HTER values were increased by 5.9 % and 14.3 %, respectively. The ionic wind heat exchanger's capacity for heat transfer is further increased using a zigzag grounding electrode. The zigzag uses a decreased aspect ratio, and the emitter is positioned slightly above the tip, improving the system's heat transfer capabilities. When compared to a heat exchanger with a flat plate grounded electrode, the four-wire electrode heat exchanger produced a 158 % increase in HTER value.

Electrohydrodynamic Enhancement of Falling Film Evaporation Heat Transfer and its Long-Term Effect on Heat Exchangers

Convective Heat Transfer Enhancement by Corona Discharge in a Wire–cylinder Electrostatic Precipitator with the Water-Cooling System

Experimental Investigation on Evaporation Heat Transfer and Pressure Drop Characteristics of HFC-161 in a Horizontal Smooth Tube

Heat transfer enhancement by electrohydrodynamics in wavy channels

Heat transfer enhancement of electrohydrodynamic (EHD) cooling system with magnetic field

An experimental study of falling film evaporation in vertical channels with perforated fins of a plate-fin heat exchanger

Experimental study on enhanced heat transfer tubes in falling film evaporation

Enhancing industrial vertical falling film evaporation through modification of heat transfer surfaces – an experimental study

Heat transfer of spray falling films over horizontal tubes with counter current airflows in an evaporative condenser

Experimental Study on Condensation and Evaporation Flow Inside Horizontal Three Dimensional Enhanced Tubes

Heat transfer performance and electrohydrodynamic characteristics optimization of a dividing-wall-type ionic wind heat exchanger

Condensation and Evaporation Heat Transfer Characteristics in Horizontal Smooth, Herringbone and Enhanced Surface EHT Tubes

Electrohydrodynamic disintegration of dielectric fluid blended with ethanol

An Experimental Study of In-Tube Condensation and Evaporation Using Enhanced Heat Transfer (EHT) Tubes

Experimental Study Of Condensation Flow Inside Horizontal Smooth, Herringbone And Three Enhanced Surface Tubes

Numerical Study on Flow Heat Transfer Characteristics of Horizontal Tube Falling-Film Evaporator

Experimental Investigation of Flow Boiling Inside Three Three-Dimensional Surface Enhanced Heat Transfer Tubes

Study on enhancement of condensation heat transfer using an electric field

CFD Study of the Thermal Performance Improvement of a Counter-Flow Heat Exchanger Using Enhanced Surface Tubes

EHD gas pump as a cooling device for electronic components in a horizontal channel

Numerical study on the flow and heat-transfer characteristics of horizontal finned-tube falling-film evaporation: Effects of liquid column spacing and wettability