Abstract:Atomic layer deposition (ALD) using multiwafer batch reactors has now emerged as the manufacturing process of choice for modern microelectronics at a massive scale. Stringent process requirements of thin film deposition uniformity within wafer (WiW) and wafer–wafer (WTW) in the batch, film conformity along submicrometer wafer features, thin film quality, and the utilization of expensive precursors in the reactor dictate ALD reactor design and process parameter optimization. This paper discusses a particle-based direct-simulation Monte Carlo (DSMC) of the full reactor scale simulation that overcomes the low Knudsen number limitation of typical continuum computational fluid dynamics approaches used for modeling low-pressure ALD reactors. A representative industrial multiwafer batch reactor used for the deposition of Si-based thin films with N2 and Si2Cl6 (hexachlorodisilane) as process feed gases with pressures in the range 43–130 Pa and a uniform reactor temperature of 600 °C is simulated. The model provides detailed insights into the flow physics associated with the transport of the precursor species from the inlets, through wafer feed nozzles, into the interwafer regions, and finally through the outlet. The reactor operating conditions are shown to be in the slip/transitional flow regime for much of the reactor volume and especially the feed gas nozzle and interwafer regions (where the Knudsen number approaches ∼0.2), justifying the need for a high-Knudsen number DSMC approach as in this work. For the simulated conditions, the nonuniformity of precursor species immediately above the wafer surface is predicted to be within <1% for a given wafer and <2% across the entire multiwafer stack. Results indicate that higher pressure degrades WiW and WTW uniformity. A reactor flow efficiency is defined and found to be ∼99%, irrespective of the chamber pressure.

Study on the Deposition Profile Characteristics in the Micron-Scale Trench Using Direct Simulation Monte Carlo Method

Deposition Profile Simulation Using the Direct Simulation Monte Carlo Method

Monte Carlo low pressure deposition profile simulations

A Stabilized Numerical Scheme to Simulate Synergistic Effect of TID and TDR in Semiconductor Devices

Monte Carlo Simulation of Defects of a Trench Profile in the Process of Deep Reactive Ion Etching of Silicon

Simulation and Experimental Verification of Silicon Dioxide Deposition by PECVD

In Situ Multi-Perspective Scanning of 3D Particle Deposition on Flat Plates with Film Cooling and Determination of Practical Model Parameters

Monte Carlo Simulation of Deposition Uniformity in the Triple-Target Magnetron Co-Sputtering System

A Monte Carlo microtopography model for investigating plasma/reactive ion etch profile evolution

Multi-model Simulation of 300 Mm Silicon-Nitride Thin-Film Deposition by PECVD and Experimental Verification

Direct-simulation Monte Carlo modeling of reactor-scale gas-dynamic phenomena in a multiwafer atomic-layer deposition batch reactor

Feature Scale Simulation of PECVD of SiO2 in SiH4/N2O Mixture

Study of Atomic Sputtering and Transport Dynamics by Monte Carlo Simulation

Modeling the Deposition of Thin Films of Transition Metal Nitrides

CFD-DEM Coupling Model for Deposition Process Analysis of Ultrafine Particles in a Micro Impinging Flow Field

The Study of Slag Particle Deposition Process Based on Monte Carlo Simulation

Three-Dimensional Simulation of DRIE Process Based on the Narrow Band Level Set and Monte Carlo Method

Monte Carlo simulations of magnetron sputtering particle transport

Monte Carlo simulation of polydisperse particle deposition and coagulation dynamics in enclosed chambers

Studying shallow junction technology by atomistic modeling

Direct Numerical Simulation on Turbulent Transportation and Thermophoretic Deposition of Micron-Sized Particles in Rectangle Channel