Abstract:In this paper, aluminium chloride crystal was used as precursor to prepare silica-alumina aerogel support by sol gel method, and the active component K2CO3 was supported on the aerogel support by incipient-wetness impregnation method to obtain a modified potassium-based adsorbent. CO2 adsorption experiment was performed on the adsorbent under different reaction conditions using a small fixed-bed reactor self designed. Based on the characterization results of low temperature N-2 adsorption-desorption experiments and scanning electron microscopy, CO2 adsorption characteristics of modified potassium-based adsorbents were studied. The prepared silica-alumina aerogel support has good microstructure and uniform pores with specific surface area and pore volume are 445.7517 m(2)/g and 2.3270 cm(3)/g, respectively, and the mesopores account for more than 99%. After loading, the active component K2CO3 is uniformly dispersed. Through model comparison, it was determined that the shrinking core model and Avrami fractional kinetic model were used to fit the experimental results in order to study the reaction kinetics and adsorption kinetics. The results show that as the temperature rises, the amount of CO2 adsorbed by the adsorbent increases first and then decreases. The increase in temperature can improve the activity of the active site of the adsorbent and make the reversible exothermic reaction occur while the adsorbent adsorbs CO2 cannot proceed in the forward direction at the same time. According to the kinetic analysis, the control period of the surface chemical reaction is too short due to the high temperature, which caused low carbonation conversion. The optimal designed loading of modified potassium-based adsorbent, reaction temperature, water vapor pretreatment time, CO2 concentration and total gas volume were 30%, 60 degrees C, 30 min, 12.5%, and 500 mL/min, respectively.

Performance of adsorption isotherms kernels of CO2 models for γ-alumina characterization

Properties of a Nano CaO/Al2O3 CO2 Sorbent

Properties of a Nano CaO/Al<sub>2</sub>O<sub>3</sub>CO<sub>2</sub>Sorbent

Synthesis, Pelleting, and Performance Evaluation of a Novel K-Promoted Γ-Alumina/mgal-layered Double Oxide Composite Adsorbent for Warm Gas H2/CO2 Separation

Experiment and Kinetic Model Study on Modified Potassium-Based CO2 Adsorbent

Molecular Dynamics Simulation of CO2 Uptake in NKPOC-1: Understanding the Temperature-Dependent Multistep Adsorption in Soft Porous Molecular Crystal

Molecular Level Models for CO2 Sorption in Nanopores

Adsorption and Decomposition of CO2 on Γ-Al2o3(1 0 0): First-principles Investigation

Studies of adsorption and porosity properties of carbon-covered alumina surfaces

Heat and mass transfer during H2O/CO2 adsorption separation using activated alumina

Adsorption and Porosity Properties of Carbon-Covered Alumina Surfaces

Geometry and Electronic Structure of the Adsorption of CO Molecules on Different Al2O3 Surfaces

A Study on the Coking Sites of Γ-Alumina Surface Using 1-Methylnaphthalene As the Model Reactant

Computer simulation of adsorption and sitting of CO2, N2, CH4 and water on a new Al(OH)-fumarate MOF

The crucial role of the K+-aluminium oxide interaction in K+-promoted alumina- and hydrotalcite-based materials for CO2 sorption at high temperatures.

CO2 Physisorption over an Industrial Molecular Sieve Zeolite: An Experimental and Theoretical Approach

Investigation of adsorption/desorption performance by aminopropyltriethoxysilane grafted onto different mesoporous silica for post-combustion CO2 capture

A Thin Film Approach to Rapid, Quantitative Measurements of Mixed-Gas Adsorption Equilibrium in Nanoporous Materials

Effect of operating parameters for CO 2 capture from syngas of supercritical water gasification using K 2 CO 3 /γ-Al 2 O 3 composite adsorbent

IAST and GCMC predictions and experimental measurements of gas mixture adsorption on three metal–organic frameworks

Mid-temperature CO 2 Adsorption over Different Alkaline Sorbents Dispersed over Mesoporous Al 2 O 3