Abstract:The morphological and textural characteristics of various silicas (93 fumed silicas and 56 porous silicas), different carbons (230), and porous polymers (53) are analyzed using probe (nitrogen, argon, benzene, n-decane, water) adsorption, small angle X-ray scattering (SAXS), and transition (TEM), scanning (SEM) electron and atom force (AFM) microscopies. There are certain correlations between pore volume (Vp) and specific surface area (SSA, SBET) for these materials. Synthesis and treatment temperatures affect this relationship since a linear Vp - SBET approximation scatter decreases with decreasing these temperatures. Silicas are composed of nonporous nanoparticles (NPNP), but activated carbons (AC) are composed of porous nanoparticles (PNP). For different materials, NP are weakly or strongly packed in secondary structures. However, there are general features of pore size distributions (PSD) for NP-based materials, e.g., minimal contribution of narrow mesopores of 3-5 nm in radius due NP-packing effects. For AC produced using the same chars and activation agents but with varied activation time, the textural characteristics demonstrate smooth changes with increasing burn-off degree: nanopores partially transform into narrow mesopores with opposite PSD shifts of broad mesopores and macropores. Comparison of adsorption (open pores accessible for probes) and SAXS (both open and closed pores) data for carbons shows that the difference decreases with increasing burn-off degree due to decreasing contribution of closed pores. Most clear pictures on the particulate morphology and texture could be obtained in parallel analysis using adsorption, SAXS, and microscopic methods with appropriate data treatments.

Studies of adsorption and porosity properties of carbon-covered alumina surfaces

Adsorption and Porosity Properties of Carbon-Covered Alumina Surfaces

Formation of A Ca12al14o33 Nanolayer and Its Effect on the Attrition Behavior of Co2-Adsorbent Microspheres Composed of Cao Nanoparticles

Uniformly carbon-covered alumina and its surface characteristics.

Uniform carbon-covered alumina synthesized by pyrolysis of sucrose/γ-Al2O3

Uniform carbon-covered alumina synthesized by pyrolysis of sucrose/gamma-Al2O3

Performance of adsorption isotherms kernels of CO2 models for γ-alumina characterization

A Density-Functional Theory Study on the Chemisorption and Stm Images of Ag(100)/O Surface

A Study on the Coking Sites of Γ-Alumina Surface Using 1-Methylnaphthalene As the Model Reactant

Geometry and Electronic Structure of the Adsorption of CO Molecules on Different Al2O3 Surfaces

Molecular Dynamics Simulation of CO2 Uptake in NKPOC-1: Understanding the Temperature-Dependent Multistep Adsorption in Soft Porous Molecular Crystal

Effect of Pore Size Distribution of Carbon‐Covered Alumina on the Preparation of Submicrometer Α‐alumina Powders

The Morphologically Controlled Synthesis and Application of Mesoporous Alumina Spheres

Investigation on the surface properties of the carbon nanotubes before and after the adsorption of polyacrylic acid

Features of the morphology and texture of silica and carbon adsorbents

The surface fractal investigation on carbon nanotubes modified by the adsorption of poly(acrylic acid)

Chemical and Structural Characterization of Amorphous and Crystalline Alumina Obtained by Alternative Sol–Gel Preparation Routes

Gas adsorption gates based on ultrathin composite polymer films

Basic Sites on Alumina with Preadsorbed Ethanol and Ammonia—An IR Study

Roughness and Porosity Characterization of Carbon and Magnetic Films Through Adsorption Isotherm Measurements

Study on the adsorption characteristics of organic contaminants on alumina surface coated with clean graphene and the influence of amorphous carbon on wetting behavior