Abstract:In biodegradable stents made from dilute Mg-Zn-Ca alloys a small number of grains constitute the thickness of a sample limiting the mechanical constrain typically seen in polycrystalline alloys. At the same time such stents are exposed to complex loading conditions, which could potentially lead to premature failure particularly in the presence of limited slip mode activation. In order to improve our understanding of the prevailing micromechanics for such conditions hot-rolled, thin strip samples were produced with thickness to grain size ratios (t/D) of 100 and 17. Samples were extracted from such thin strips and subjected to interrupted cyclic four-point bending in order to study the in-grain misorientation axis (IGMA) evolution of selected grains during cyclic loading using quasi-in-situ electron back-scattered diffraction (EBSD). Grains were selected at the tensile and compressive faces of samples, and in the vicinity of the neutral band. Analysis of the evolution of IGMA and misorientation profiles during the bending showed that extension twinning was the dominant deformation mode in the compressive region for both t/D ratios. In addition, non-basal -type slip systems were active as a result of work hardening. In the tensile region, the activity of -type non-basal slip systems was observed for the t/D of 100, but basal/double basal slip was the dominant deformation mode for the t/D of 17. No signs of failure were observed for the sample with a t/D of 17 at the tensile region, implying that these basal slip modes can accommodate deformation largely without the assistance of other deformation modes. The neutral band evolution was mapped using grain orientation spread (GOS) analysis. In contrast to the continuum mechanics solution, a neutral band was observed instead of an axis. The position of the neutral band was dependant on the local orientation organization of the grains and the extent of work-hardening.

Effect of strain state on the linear expansion coefficient of Zr-Nb-Cu-Fe amorphous alloys

The effect of mechanical strains on the ferroelectric and dielectric properties of a model single crystal ? Phase field simulation

Static mechanical characterization of a bulk amorphous and nanocrystalline Zr40Ti14Ni11Cu10Be25 alloy

Experimental teaching design of plastic size effect of Zr based amorphous alloy under room temperature compression

Effects of Strain on the Half-Metallic and Elastic Properties of FeCrTe and CoCrSi with Clb Structure

Strain-Rate-Dependent Deformation Behavior of Ti29Zr24Nb23Hf24 High Entropy Alloys at Elevated and Room Temperature

Research on the processes of deformation and failure in coarse- and ultrafine-grain states of Zr1–Nb alloys by digital image correlation and infrared thermography

Structure and cryogenic mechanical properties of severely deformed nonequiatomic alloys of Fe–Mn–Co–Cr system

Deformation behavior and Microstructural evolution of Zr‐Sn‐Nb‐Fe alloy over a wide temperature range based on the law of mixture

The effect of changes in Al-based amorphous phase structure on structure forming upon crystallization

In situ X-ray diffraction strain-controlled study of Ti–Nb–Zr and Ti–Nb–Ta shape memory alloys: crystal lattice and transformation features

Regularities of Changes in the Structure of Different Phases of Deformed Zirconium Alloys as a Result of Raising the Annealing Temperature According to Texture Analysis Data

Effects of Zr on high temperature deformation and dynamic precipitation of laves phase in Fe–13Cr–5Al–2Mo–0.5Nb–0.4Ta alloy

Size effects and the deformation behaviour of a dilute Mg-Zn-Ca alloy subjected to cyclic four-point bending

The Essence of the Effect of Strain Rate on the Mechanical Behavior of the Fe14.6Ni (at%) Elastocaloric Refrigeration Alloy: a Molecular Dynamics Study

Effect of High Temperature Deformation on the Low Thermal Expansion Behavior of FE-29%NI-17%CO Alloy

Yield-stress anomaly in equiatomic ZrNbTiVHf high-entropy alloys

Experimental Determination of a Strain State in a Bulk Forming of a Low Carbon Steel

Dynamic Strain-Rate Effect On Uniaxial Tension Deformation Of Ti5al2.5sn Alpha-Titanium Alloy At Various Temperatures

Temperature effect on tensile behavior of an interstitial high entropy alloy: Crystal plasticity modeling

Strain intermittency in shape-memory alloys