Abstract:One of the most challenging operating conditions to be certified for FAR33 & FAR25 requirements is ground crosswind condition. When "Engine" is operated using the designed inlet and nacelle, within the flight envelope, could accommodate inlet separation/distortion resulted from crosswind and high angle-of-attack operating conditions. Inlet flow separation and distortion could trigger fan or core stall, as well as induce high fan and/or engine vibrations. The air induction system or inlet of the engine is designed to provide velocity and pressure distributions with minimum distortion and maximum pressure recovery to the propulsion system. Engine-inlet-airframe compatibility is one of the major tasks required to be evaluated in detail during the engine developing phase.This research is a parametric study of using CFD to evaluate operational characteristics of the air induction system. Comparisons of various inlet designs are made and characterized into three categories, i.e., i) Inlet flow recovery, ii) Inlet flow distortion, iii) Inlet Mach distribution. The objective is to assess the impact of air induction design of turbofan upon inlet compatibility. The current research work includes four parts, i.e., i) A geometry modeling process of nacelle, inlet, wing and fuselage, ii) A meshes generator ICEM iii) The ANSYS CFX CFD software which could achieves numerical simulation and post-processing, iv) The Matlab platform with the function of coupling all considerations listed above for inlet compatibility optimization, based on genetic algorithm and Kriging agent model.The research introduces the Kriging model and weighting coefficient to optimize total pressure loss coefficient and static pressure recovery coefficient, with the external nacelle flow ignored. Bezier equation was used to fit the optimized curves obtained by changing two control points at the inter surface of nacelle. The wing-mounted model coupled with the nacelles, fuselage and wings was then built to make the assessment of inlet compatibility of air intake system relative to the isolate model. Comparison of aerodynamic performance was then made between the original and optimal nacelle, to show correlation between inlet compatibility and air intake profile.

Airframe/Propulsion Integration at Transonic Speeds

Research status and development trend of air-breathing high-speed vehicle/engine integration

Aerodynamics of aero-engine installation

High-fidelity numerical investigations of rotor-propeller aerodynamic interactions

Nacelle Aerodynamic Optimization and Inlet Compatibility

Aerodynamic Interaction Mechanisms in Typical Wingtip-Mounted Tractor Propeller Configurations

Experimental and numerical investigation on the effect of turboprop engine exhaust gas impingement on pusher aircraft

Aerodynamic study of a bifurcated turboprop engine inlet with a propeller for flow at ground suction conditions

The CF6 engine performance improvement

Aerodynamics/propulsion integrated modeling for control of hypersonic vehicle

Numerical and experimental investigations of diffusion-induced boundary layer separation on aero-engine nacelles

Study of the Aerodynamic Characteristics on the Computed Flowfield During Thrust Reversers Operation

Design point analysis of the turbofan-driven turboelectric distributed propulsion system with boundary layer ingestion

Nacelle, Air Intake Aerodynamic Design And Inlet Compatibility

A Rapid Method of Integrated Aeropropulsive Analysis for the Conceptual Design of Airbreathing Hypersonic Aircraft

Conceptual design and integration of a propulsion system for a supersonic transport aircraft

Fundamental considerations in the design and performance assessment of propulsive fuselage aircraft concepts

Experimental study of airfoil-propeller interac-

Aero-thermal investigation of thermal interactions between turboprop engine exhaust and selected parts of the airplane skin for tractor configured aircraft

Wind Tunnel Investigation of Transient Propeller Loads for Non-Axial Inflow Conditions

Wind tunnel experiments of interstage segments used for aerodynamic control of retro-propulsion assisted landing vehicles