Abstract:As observed experimentally and numerically, the blade cavitation in a waterjet pump presents multi-temporal-spatial scales under the inlet guide vanes (IGVs) wake perturbations. Meanwhile, the phase effects on blade cavitation are specifically identified and confirmed to contribute to loadings and force spectrum instabilities. In light of this, the state-of-the-art multiresolution-proper orthogonal decomposition (MRPOD) and dynamic mode decomposition (MRDMD) are employed to separate the cavitating flow scales regarding to tonal- and broadband-spectrum (TS and BS respectively) to perform a space-time-frequency analysis. The results show that the surface cavitation on the adjacent blades globally evolves in a distinct way due to the phase difference between IGVs and rotor blades. As resolved by MRPOD, the TS oscillations are mainly arising around where cavitation dynamically develops, which is majorly attributable to the rotor-stator interference (RSI). The BS oscillations are in general emerging closing to hub regimes wherein usually deviate from the design operating point and perform more flow instabilities. Comparatively, the MRDMD identifies a frequency-jittering spectrum that slightly oscillates around the IGVs passing frequency, which is physically triggered by the cavitation-enhanced irregular loading impingements. The MRDMD relevant TS modes perform similar tendencies as MRPOD but alternatively oscillate with time around the leading edge due to the initial phase difference. The studies on pump cavitation dynamics accounting phase effects via multiresolution analysis (MRA) aim to gain a fundamental understanding of the cavitation-induced vibration to facilitate its control.

Spectral analysis of gaseous cavitation in water through multiphase mathematical and acoustic methods

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Numerical Simulation of Nonlinear Phenomena in a Standing-Wave Thermoacoustic Engine with Gas-Liquid Coupling Oscillation

Analysis of Ventilated Cavitation Around A Cylinder Vehicle with Nature Cavitation Using A New Simulation Method

Wavelet-based Multiresolution Analysis of Cavitation-Induced Loading Instabilities under Phase Effect in a Waterjet Pump

Cavitation Characterization of Fluid Machinery Based on Cyclostationary Analysis: Part 1—Cavity Type Identification by Carrier Distribution

Dissolved air effects on three-phase hydrodynamic cavitation in large scale Venturi- Experimental/numerical analysis

Acoustic analysis on jet-bubble formation based on 3 D numerical simulations

Cavitation Characterization of Fluid Machinery Based on Cyclostationary Analysis: Part 2-Cavity Development Evaluation by Modulation Intensity

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Numerical Simulation of Ventilated Cavitation Evolution with an Insight on How Ventilation Influences Pressure Fluctuation and Cavitation Noise

Modeling Cavitation Flow of Cryogenic Fluids with Thermodynamic Phase-Change Theory

Hydrodynamic cavitation phenomena and flow instabilities in wastewater treatment: A multiphase VOF study with a venturi cavitator

A new cavitation model based on evaporation and condensation theory

Modelling vaporous cavitation on fluid transients

Numerical simulation of pipeline ultrasonic cavitation based on CFD

Numerical Analyses of Ventilated Cavitation over a 2-D NACA0015 Hydrofoil Using Two Turbulence Modeling Methods

Modeling and simulation of the cavitation phenomenon in turbopumps

Investigation of the cavitation model in an inducer for water and liquid nitrogen

Extended Bubble Cavitation Model to predict water hammer in viscoelastic pipelines

NUMERICAL STUDY OF CAVITATION FLOW AROUND A BLUNT CYLINDRICAL OBJECT