Abstract:Resin matrix composites are commonly utilized in water-lubricated stern tube bearings for warship propulsion systems. Low-speed and high-load conditions are significant factors influencing the tribological properties of stern tube bearings. The wear characteristics of resin-based laminated composites (RLCs), resin-based winding composites (RWCs), and resin-based homogeneous polymer (RHP) blocks were investigated under simulated environmental conditions using a ring-on-block wear tester. Simulated seawater was prepared by combining sodium chloride with distilled water. The wetting angle, coefficient of friction (COF), and mass loss were measured and compared. Additionally, their surface morphologies were examined. The results indicate a significant increase in the COFs for the three materials with an increased speed or load under dry conditions. The COF of the RLCs is the lowest, indicating that it has superior self-lubricating properties. In wet conditions, the COFs of the three materials decrease with an increasing speed or load, exhibiting a pronounced hydrodynamic effect. The COF and mass loss of RWCs are the highest, while RLCs and RHP exhibit lower COFs and mass loss values. The reticulated texture and flocculent fibers on the surface of RLC enhance the heat diffusion and improve the material wettability and water storage capacity. The surface of RWC is dense, and the friction area under dry conditions is melted and brightened. The surface of RHP is smooth, while the worn material forms an agglomerate and exhibits susceptibility to burning and blackening under dry conditions. The laminated formation method demonstrates superior tribological performance throughout the wear evolution process.

Study on Lubrication Performance of Composites Water-Lubricated Stern Bearing

Frictional Wear Behavior of Water-Lubrication Resin Matrix Composites under Low Speed and Heavy Load Conditions

A Comparative Investigation of the Tribological Behavior and Wear Mechanism of Bronze-graphite Composite under Dry- and Water-lubricated Sliding Against Steel

Experimental research on marine oil-lubricated stern tube bearing

Friction-Induced Vibration and Noise in Water-Lubricated Stern Bearings: A Comprehensive Review of Mechanisms and Design

Tribological behavior of modified polyetheretherketone composites in sliding against stainless steel under water lubrication

Friction and Wear of Self-Mated SiC and Si 3 N 4 in Green Water-Based Lubricant

A novel approach to investigate temperature field evolution of water lubricated stern bearings (WLSBs) under hydrodynamic lubrication

Simulation and experimental investigations on water-lubricated squeeze film damping stern bearing

Theoretical and experimental study on the fluid-structure-acoustic coupling dynamics of a new water lubricated bearing

Film-Thickness Identification Method and Lubrication Characteristic Experiment of Full-Size Water-Lubricated Stern Bearing under Offset Load

Research on the Influence of Ship Stern Shaft Deformation to Journal Bearing Lubricant Property

Vibration Reduction Performance of Damping-Enhanced Water-Lubricated Bearing Using Fluid-Saturated Perforated Slabs

Review of the evolution and prevention of friction, wear, and noise for water-lubricated bearings used in ships

Experimental Study on Material Properties of Bearing Bush of Water Lubricated Bearing

Tribological modification of hydrogenated nitrile rubber nanocomposites for water-lubricated bearing of ship stern shaft

Influence of Water and Oil Immersion on the Tribological Properties of Excentrodendron Hsienmu

Tribological and Vibration Properties of Three Different Polymer Materials for Water-Lubricated Bearings

Researches on Friction Performance of Water-Lubricated Polymer Composite Journal Bearings Based on Experiments

Effect of hollow-tube structure on the tribological performance of biomimetic water-lubricated bearing material

Theoretic and Experimental Research on the Influence of Ship Stern Bearing Deformation to its Carrying Capacity