A 10-Gb/s 5-Tap DFE/4-Tap FFE Transceiver in 90-Nm CMOS Technology
John F. Bulzacchelli,Mounir Meghelli,Sergey V. Rylov,Woogeun Rhee,Alexander V. Rylyakov,Herschel A. Ainspan,Benjamin D. Parker,Michael P. Beakes,Aichin Chung,Troy J. Beukema,Petar K. Pepejugoski,Lei Shan,Young H. Kwark,Sudhir Gowda,Daniel J. Friedman
DOI: https://doi.org/10.1109/jssc.2006.884342
IF: 5.4
2006-01-01
IEEE Journal of Solid-State Circuits
Abstract:This paper presents a 90-nm CMOS 10-Gb/s transceiver for chip-to-chip communications. To mitigate the effects of channel loss and other impairments, a 5-tap decision feedback equalizer (DFE) is included in the receiver and a 4-tap baud-spaced feed-forward equalizer (FFE) in the transmitter. This combination of DFE and FFE permits error-free NRZ signaling over channels with losses exceeding 30 dB. Low jitter clocks for the transmitter and receiver are supplied by a PLL with LC VCO. Operation at 10-Gb/s with good power efficiency is achieved by using half-rate architectures in both transmitter and receiver. With the transmitter producing an output signal of 1200 mVppd, one transmitter/receiver pair and one PLL consume 300 mW. Design enhancements of a half-rate DFE employing one tap of speculative feedback and four taps of dynamic feedback allow its loop timing requirements to be met. Serial link experiments with a variety of test channels demonstrate the effectiveness of the FFE/DFE equalization.