Abstract:Noises generated from modular bridge expansion joints during vehicle pass-bys have been causing local environmental problems recently. Previous experimental studies showed that possible causes of dominant noise components generated from the bottom side of the joint might be different from those from the top side. The objective of this study was to obtain theoretical insights into the mechanism of noise generation from the bottom side of the joint for which a main noise source might be structural vibration of the joint. Vibro-acoustic analysis was conducted based on the information from a full-scale model of modular expansion joint obtained in previous experimental studies. The dynamic behavior of the joint model was investigated by using the finite element method (FEM) and the sound field inside the cavity located beneath the joint model was analyzed by using the boundary element method (BEM). Indirect BEM was used to calculate the sound pressure inside the cavity with the velocity response obtained by the FE analysis as a boundary condition. The frequency range considered in the analysis was 20–400 Hz where dominant frequency components were observed in the noise measured in the cavity beneath the joint in the previous experiment. It was intended to interpret numerical results obtained by a model developed with available mechanical properties of the joint components to seek a general understanding of the noise generation mechanism of the modular expansion joint. It was observed that the peaks in the spectrum of noise inside the cavity were due to resonances of structural vibration modes of the joint and/or resonances of acoustic modes of the cavity. There was evidence that showed possible interaction between structural modes of the joint and the acoustic modes of the cavity.

Vibro-acoustic analysis of noise generation from a full scale model of modular bridge expansion joint

Mechanism of noise generation from a modular expansion joint under vehicle passage

Dynamical Behavior of Steel Box Girder Bridges Due to Vehicle-Induced Vibration at Expansion Joint

Study on low-frequency noise radiated from steel multi-box girder bridge induced by traffic vibration

Analysis on Low-Frequency Noise Induced by Vehicle-Bridge Coupling Vibration

Assessment on Transient Sound Radiation of a Vibrating Steel Bridge Due to Traffic Loading

A Numerical Method for Analyzing the Low-Frequency Noise of Bridge under Vehicle Load

Assessment of Sound Pressure of Transient Noise Radiated from Vehicle-Bridge Coupling Vibration

Theoretical analysis of low-frequency noise radiated from bridge vibrations

Analysis and control of bridge expansion joint croaking noise

Influence of the Acoustic Cover of the Modular Expansion Joint on the Acoustic Climate in the Bridge Structure Surroundings

Low-frequency noise radiation from traffic-induced vibration of steel double-box girder bridge

Measurement and analysis of bridge expansion joint noise

An Integrated Joint Dynamics System for Elastically Jointed Structures

Vibration and Acoustic Radiation Characteristics of A Low Voltage Busbar Bridse System

Study of noise originating from selected bridge expansion joints

An analysis method of vehicle–bridge coupling vibration considering effects of expansion joint parameters and its application

Sound Damage Detection of Bridge Expansion Joints Using a Support Vector Data Description

Modeling and Analysis of 1:3 Internal Resonance of Suspension Bridge Under Boundary Excitations

On the influence of local deformation on structural dynamic models of bolted lap joints

Investigation of ambient noise seismological methods on a bridge model