Abstract:The effect of temperature on the tensile properties and deformation mechanism of GH4169 alloy has been systematically studied over a wide range of room temperature (RT) to 1000 °C. The results indicate that the stress–strain curve of the alloy shows serrations at 200–600 °C, and the character of the serrations changes from type A to type B and then to type C at different temperatures. The ultimate tensile strength of the alloy decreases gradually from RT to 600 °C. The yield strength decreases slowly from RT to 700 °C but decreases rapidly above 800 °C. Transmission electron microscopy analysis relieves that the primary deformation mechanism of the alloy below 500 °C is Orowan bypass mechanism. At temperatures between 600 and 700 °C, the coordinated deformation of twins and cross-slip of dislocations are activated. The transformation of ^'' phase to δ phase above 650 °C will decrease the strength. The primary deformation mechanism above 800 °C transforms into the repeated shearing of ^'' by dislocations to form multiple stacking faults. Recrystallized grains were observed above 800 °C, and continuous dynamic recrystallization and discontinuous dynamic recrystallization were observed. The stress concentration caused by Nb-rich carbides is the cause of intracrystalline crack nucleation. At 700 °C, grain boundary crack sprouting is caused by the combined effect of slip band impact on grain boundaries and grain boundary dislocation plugging. The relationship between the serrated flow behavior and the deformation mechanism has been discussed based on the experimental results.

Creep crack growth of GH3535 alloy at elevated temperatures

An Investigation of the Effect of High-Temperature Cyclic Straining and Creep Loading on Tensile Mechanical Properties of GH4145/SQ Alloy

Effect and mechanism of constraint on creep crack growth behavior of GH3535 alloy

Rupture Mechanism of GH2984 Crept at Temperature Between 700-750℃

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

A Concise Binomial Model for Nonlinear Creep-Fatigue Crack Growth Behavior at Elevated Temperatures

Low Cycle Fatigue and Creep Fatigue Interaction Behavior of 9Cr-0.5Mo-1.8w-v-nb Heat-Resistant Steel at High Temperature

Correlation of Creep Fracture Lifetime with Microstructure Evolution and Cavity Behaviors in G115 Martensitic Heat-Resistant Steel

Creep Behavior and a Deformation Mechanism Based Creep Rate Model under High Temperature and Low Stress Condition for Single Crystal Superalloy DD5

Creep behaviors and deformation mechanisms at intermediate temperatures in a novel γ‐γ' nickel‐based superalloy

Experimental Method for Creep Crack Growth Testing in Controlled Environments at High Temperatures

Creep behaviors of fine-grained Ni-base powder metallurgy superalloys at elevated temperatures

Study on Creep Behaviors of GH3230 Superalloy With Side Notches or a Center Inclined Hole at 900°C and 1000°C

Microstructure and Property Evolutions of a Novel Super304H Steel During High Temperature Creeping

The Influence of Stress Levels on the Creep Behavior of Ti–42Al–6Nb–0.05Y2O3 Alloy

Temperature Dependence in Tensile Properties and Deformation Behavior of GH4169 Alloy

Crack growth behavior of low carbon steel at high temperature

Effects of stress and temperature on creep behavior of a new third-generation powder metallurgy superalloy FGH100L

Grian Size Effect on the Initiation and Propagation of Small Fatigue Crack of GH4169 Alloy at Room Temperature and 650 ℃

Effect of Specimen Size on Creep Crack Growth Rate in Superalloys IN625 and IN783

Constitutive Equation and Hot Deformation Behavior of SLM-GH3536 Alloy