Cotton Cellulose 1, 2, 3, 4 Buthanetetracarboxylic Acid (BTCA) Crosslinking Monitored by some Physical—chemical Methods

Olivera Šauperl,Karin Stana-Kleinschek,Volker Ribitsch

DOI: https://doi.org/10.1177/0040517508096222

IF: 2.3

2009-05-21

Textile Research Journal

Abstract:In this research, the influence of the alkaline modification of cotton cellulose on the crosslinking with 1, 2, 3, 4 buthanetetracarboxylic acid (BTCA) is investigated. In order to anticipate changes after alkaline modification the crystallinity change was evaluated using wide angle X-ray diffraction (WAXD), iodine adsorption measurements, and the Knecht method. Tensiometry, the methylene blue method, and the streaming potential method enable hydrophilic/hydrophobic character estimation, carboxyl group content determination, evaluation of dissociation/sorption fiber characteristics, as well as electrokinetic properties characterization. All these parameters define the changes at the accessible polymer surfaces and therefore reflect the relationship between the changed crystallinity and the incorporation of the BTCA molecules into accessible regions of cotton cellulose. It has been concluded that the crystallinity degree characterizes crosslinking effectiveness of cotton cellulose crosslinked with BTCA. Mercerized materials show after crosslinking higher contact angles and retain a higher number of carboxyl groups. Electrokinetic properties are in correlation with carboxyl group amount. It has been confirmed that the physical—chemical methods which were used in this research are suitable methods for the crosslinking efficiency evaluation.

materials science, textiles

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to study the effect of alkali treatment (especially through the Maillard reaction process) on the cross - linking reaction between cotton cellulose and 1,2,3,4 - butane tetracarboxylic acid (BTCA). Specifically, the researchers are concerned with:

1. **Change in crystallinity**: Evaluate the change in crystallinity of cotton cellulose after alkali treatment by wide - angle X - ray diffraction (WAXD), iodine adsorption measurement and Knecht method.
2. **Change in hydrophilic/hydrophobic properties**: Use tensiometry, methylene blue method and streaming potential method to evaluate the hydrophilic/hydrophobic characteristics of the material surface and the change in charge state.
3. **Evaluation of cross - linking efficiency**: Comprehensively evaluate the effectiveness of the cross - linking between cotton cellulose and BTCA by the above - mentioned physicochemical methods, especially for cotton cellulose after alkali treatment (such as Maillard reaction).

The main objective of the research is to understand how alkali treatment changes the microstructure of cotton cellulose, and then affects its cross - linking reaction with BTCA, so as to provide theoretical basis and technical support for the modification of textiles. These changes not only affect the mechanical properties of the material, but may also affect its practical properties such as hygroscopicity and dyeing properties.