Abstract:The thermoluminescent material CaF 2 (Tm), known as TLD-300 (Harshaw/Bicron), shows a remarkable dependence of its glow curve shape on the quality of the radiation field. The quotient of high-temperature (maximum at about 265 °C) and low-temperature peaks (maximum at about 175 o C) depends strongly on LET (ions) and photon energy. The shape of the glow curve is parameterized by the high-to-low-temperature ratio, HLTR, a decreasing function of photon energy. Our goal has been to investigate the TLD-300 glow curve shape for six photon energies between 6 and 28 keV, and to apply this extended HLTR calibration to determine the effective energy of triboluminescence-generated X-rays (TGXs) produced when peeling adhesive tape in vacuum. For calibration, TLD-300 chips were exposed to X-rays from a W-anode tube (9.7- 27.7 keV effective energies), X-rays from a Cu-anode tube (8.0 keV) and a 55 Fe radioactive source (5.9 keV). The chips were subjected to an annealing protocol designed to improve the stability of the low-temperature peaks. Doses were low and deconvolution into 7 peaks was performed with custom software. For the TGXs investigation, TLD-300 chips and TLD-100 microcubes were exposed inside a vacuum chamber to radiation generated by the peeling of adhesive tape from its own backing. The dosimeters, located at different angular positions with respect to the tape, were covered with a 21-micrometer thick layer of Mylar (Dupont Tejjin Films) to eliminate stray radiation and block any UV light that may be emitted along with the TGXs. TLD-300 were thermally handled as in calibration, and the HLTR indicated the effective energy. Microcubes were used as monitors of a controlled exposure. The new calibration data confirmed the previous trend and showed consistency with existing HLTR measurements above 30 keV (after correcting by the different annealing procedures). The TGXs TLD-300 glow curves showed the presence of a low-temperature peak below those included in the usual deconvolution. The measured HLTR indicated effective energies close to 7 keV and constant over a wide range of observation angles. The extended calibration validates the use of this technique to evaluate photon energies below the limits investigated previously. For the investigation of TGXs, TLDs have been used as passive dosimeters, offering new possibilities in cases where pileup would be a limiting factor for active solid-state active detectors. The difference in glow curve shapes between the TGXs and the calibration photons offers a tool for further investigation of processes induced by surface electrification.

Reappraisal of Peak Shape Method Based on Average Geometrical Symmetry Factor and Its Application to Thermoluminescence Glow Curves

Non-empirical peak shape methods based on the physical model of the one trap one recombination center model

A critical look at the kinetic models of thermoluminescence—II. Non-first order kinetics

Development of computer code for deconvolution of thermoluminescence glow curve and DFT simulation

Toward an Accurate Description of Thermally Activated Delayed Fluorescence: Equal Importance of Electronic and Geometric Factors

TL-SDA: A designed toolkit for the deconvolution analysis of thermoluminescence glow curves

Characterization of the thermoluminescence glow curve of Li2B4O7:Cu,Ag

Topology-dependent thermoluminescence kinetics

Kinetic Parameters analysis of GdAlO$_3$ based on thermoluminescent phenomenon

The shape of the TLD-300 glow curve as a function of the energy for photons below 30 keV: Application to triboluminescence X-rays from peeling adhesive tape.

The thermoluminescence glow curves of LiF:Mg,Ti: characteristics and mechanisms

Fundamental Theories of TADF

Significant Contribution of Deeper Traps for Long Afterglow Process in Synthesized Thermoluminescence Material

Importance of evaluating the excitation intensity dependence of the temperature-dependent luminescence: Impact on optical thermometry and anti-thermal quenching performance

Calculation and properties of trap structural functions for various spatially correlated systems

Study Of Thermoluminescence Characteristics Of Quartz For High Radiation Doses (>1Kgy): Implications For Extending The Luminescence Dating Range

Photoluminescence and Thermoluminescence Glow Curve Analysis of Calcite Collected From Meghalaya Basin

Thermoluminescence dosimetry: State-of-the-art and frontiers of future research

Synthesis, characterization and thermoluminescence of MgO:Li,Tb,Sm phosphor for high dose gamma dosimetry applications

Investigation of thermoluminescence response and trapping parameters of natural barite samples from Dongargaon mine, India

Analytical description of the charge-to-photon conversion efficiency for electroluminescent devices based on thermally activated delayed fluorescence