Abstract:Dual Active Bridge (DAB) converters have gained popularity in electric vehicle charging stations due to their high efficiency and electrical isolation. As the demand for high-powered devices and large-capacity energy storage systems grows, charging systems that integrate multiple interconnected DAB modules are emerging as a promising solution. However, prolonged operation of these modules at high power levels can cause parameter deviations from the initial DAB circuit, resulting in power variations between modules. To overcome parameter deviations, this study presents an enhanced power control approach based on output resistance adjustment, intending to achieve consistent output capacity for multiple DAB modules. In the proposed enhanced power control method, the output resistance of the DAB module is considered to be controllable, and the current-sharing mismatches among DAB modules are fed back to tune the converter output resistance for mitigating current mismatches between modules. Thanks to the proposed control method, each DAB module can operate autonomously and balance the charging current between modules. When one DAB module is suddenly cut out of the system, the other DAB modules still maintain their stability with fully guaranteed load capacity. To demonstrate the feasibility of the enhanced control approach, the small signal model of the DAB system with three modules is derived together with its frequency-amplitude diagram. Then, the effect of virtual resistance on current balancing is comprehensively tested, and the proper control signal with virtual resistance is added to the DAB voltage control loop. The simulation results have demonstrated the reliability of the proposed control method with the ability to balance the charging current between modules and stabilize the system when a single DAB module fails.

A Load-Current-Estimating Scheme With Delay Compensation for the Dual-Active-Bridge DC–DC Converter

An LLC -DAB Bidirectional DCX Converter with Wide Load Range ZVS and Reduced Switch Count

Coupled-Inductor-Based Dual Active Bridge Converter With Soft Switching Capability and Low Component Count

Modeling and Analysis of 2/3-Level Dual-Active-Bridge DC-DC Converters with the Five-Level Control Scheme

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

Power-Estimation-Based Synchronous Rectification Solution for Bidirectional DAB-LLC Converter

Decoupled Dual-PWM Control for Naturally Commutated Current-Fed Dual-Active-Bridge DC/DC Converter

A Simple DC-Offset Eliminating Method of the Series-Inductance Current for the DAB DC–DC Converter

A Dual-Transformer-Based Hybrid Dual Active Bridge Converter for Plug-in Electric Vehicle Charging to Cope with Wide Load Voltages

Optimal Control of Multi-Level DAB Converters for Soft-Switching and Minimum Current Stress

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

Dynamic Control of Three-Phase Dual-Active-Bridge DC-DC Converters Based on Sliding-Mode-Learning Adaline

Steady-State and Transient DC Magnetic Flux Bias Suppression Methods for a Dual Active Bridge Converter

Improved Model-Based Phase-Shift Control for Fast Dynamic Response of Dual-Active-Bridge DC/DC Converters

Virtual Current Based Direct Power Control Strategy Of Dual-Active-Bridge Dc-Dc Converter

A Simple and Fast Start-up Strategy for Dual Active Bridge Converters with DC Bias Suppression

Novel resistance control scheme for mitigating current sharing mismatches in parallel dual active bridge converters for DC fast charging stations

Current Sensorless Control for Dual Active Bridge DC–DC Converter with Estimated Load-Current Feedforward

An Enhanced Dual Active Bridge Converter With Full Domain ZVS by Utilizing a Simple Segment Control for Wide Voltage Range Applications

Improved dynamic response strategy with dual phase‐shift control for dual‐active‐bridge DC–DC converter

Composite Duty Modulation of Dual Active Bridge Converters to Minimize Output Voltage Ripples and Inductor RMS Currents