Abstract:Multi-level dual-active-bridge (DAB) DC-DC converters offer higher voltage-blocking capability and larger stepup ratios, as well as increased number of degrees of freedom (DoFs) compared to the traditional two-level DAB converter. Thus, it has potential to be used in medium-voltage DC (MVDC) systems. However, the control complexity of the multi-level DAB converters also increases along with the number of DoFs. When soft-switching is considered as an optimization objective together with other performance indices (e.g., peak or root-mean-square values of the inductor current), the analytical solutions will be difficult to derive due to the increased number of control variables and complicated soft-switching constraints. To address this issue and improve the efficiency of the DAB converter, this paper proposes a control strategy for a multi-level DAB converter to achieve both soft-switching and minimum current stress simultaneously. The analytical solutions are calculated by improved Karush-Kuhn-Tucker (KKT) conditions, where the numerical solutions are used to locate the operating modes and determine the zero-voltage-switching (ZVS) boundaries. This can simplify the Lagrangian function and inequality constraints, and then, the analytical solutions can be obtained by the simplified KKT conditions. In addition, a comprehensive comparison between the quasi-ZVS and strict-ZVS control is carried out, so that the converter efficiency, implementation complexity, and smooth transition between different power levels can be compromised for practical applications. Finally, the performances of the proposed control strategy in terms of current stress minimization and softswitching operation are validated by experimental tests.

Current Sensorless Control for Dual Active Bridge DC–DC Converter with Estimated Load-Current Feedforward

Current Sharing Based on Incremental Passivity and Unknown Load Finite-Time Estimation for Multilevel Connected DC–DC Converters

Minimum Current Control for Under-Resonant Dual-Bridge-Series-Resonant Converter

Study on dual active bridge DC-DC converter based on second dual-phase-shifting control

Enhancement of DC‐bus Voltage Regulation in Cascaded Converter System by a New Sensorless Load Current Feedforward Control Scheme

Stabilization Of Dc-Dc Buck Power Converter Feeding A Mixed Load Using Passivity-Based Control With Nonlinear Disturbance Observer

Dynamic Control of Three-Phase Dual-Active-Bridge DC-DC Converters Based on Sliding-Mode-Learning Adaline

Optimal Control of Multi-Level DAB Converters for Soft-Switching and Minimum Current Stress

Nonlinear Average Current Control Using Partial Current Measurement

A Novel Control Method for Eliminating DC Bias in Dual-Active-Bridge DC-DC Converters

Decoupled Dual-PWM Control for Naturally Commutated Current-Fed Dual-Active-Bridge DC/DC Converter

Integrated Optimization of Dual-Active-Bridge DC–DC Converter with ZVS for Battery Charging Applications

Predictive valley-peak current control of isolated bidirectional dual active bridge DC-DC converter

Second Harmonic Current Reduction of Dual Active Bridge Converter under Dual-Phase-shift Control in Two-Stage Single-Phase Inverter for Residential Energy Storage System

Current Estimation and Optimal Control in Multiphase DC–DC Converters With Single Current Sensor

A Load-Current-Estimating Scheme With Delay Compensation for the Dual-Active-Bridge DC–DC Converter

Virtual Current Based Direct Power Control Strategy Of Dual-Active-Bridge Dc-Dc Converter

Dynamic Enhancement for Dual Active Bridge Converter with a Deadbeat Current Controller

Deadbeat Current Controller for Bidirectional Dual-Active-Bridge Converter Using an Enhanced SPS Modulation Method

A Novel Feedforward Scheme for Enhancing Dynamic Performance of Vector-Controlled Dual Active Bridge Converter with Dual Phase Shift Modulation for Fast Battery Charging Systems

Disturbance-Observer-Based DC-Bus Voltage Control for Ripple Mitigation and Improved Dynamic Response in Two-Stage Single-Phase Inverter System