Abstract:The elastic properties of 1D nanostructures such as nanowires are often measured experimentally through actuation of the nanowire at its resonance frequency, and then relating the resonance frequency to the elastic stiffness using elementary beam theory. In the present work, we utilize large scale molecular dynamics simulations to report a novel beat phenomenon in [110] oriented Ag nanowires. The beat phenomenon is found to arise from the asymmetry of the lattice spacing in the orthogonal elementary directions of the [110] nanowire,i.e., [-110] and [001] directions, which results in two different principal moments of inertia. Because of this, actuations imposed along any other direction are found to decompose into two orthogonal vibrational components based on the actuation angle relative to these two elementary directions, with this phenomenon being generalizable to <110> FCC nanowires of different materials (Cu, Au, Ni, Pd and Pt).The beat phenomenon is explained using a discrete moment of inertia model based on the hard sphere assumption, the model is utilized to show that surface effects enhance the beat phenomenon, while the effect is reduced with increasing nanowires cross-sectional size or aspect ratio.Most importantly, due to the existence of the beat phenomena, we demonstrate that in resonance experiments only a single frequency component is expected to be observed, particularly when the damping ratio is relatively large or very small.Furthermore, for a large range of actuation angles, the lower frequency is more likely to be detected than the higher one,which implies the experimental predictions of Young's modulus obtained from resonance may in fact be under predictions. The present study therefore has significant implications for experimental interpretations of Young's modulus as obtained via resonance testing.

Winkler boundary conditions for three-point bending tests on 1D nanomaterials

Modified Beam Theories for Bending Properties of Nanowires Considering Surface/Intrinsic Effects and Axial Extension Effect

Bending Properties of Ag Nanowires with Pre-Existing Surface Defects

In Situ Observation of High Bending Strain Recoverability in Au Nanowires

Beat Phenomena in Metal Nanowires, and Their Implications for Resonance-Based Elastic Property Measurements.

Surface Effects on In-Plane Buckling of Nanowires on Elastomeric Substrates

Theoretical and numerical investigation of bending properties of Cu nanowires

Nanobeam Mechanics: Elasticity, Strength, and Toughness of Nanorods and Nanotubes

Vibration Analysis of Fluid-Conveying Nanotubes Embedded in an Elastic Medium Considering Surface Effects

Nonlinear deformation analysis of magneto-electro-elastic nanobeams resting on elastic foundation by using nonlocal modified couple stress theory

Surface Effects in Various Bending-Based Test Methods for Measuring the Elastic Property of Nanowires

Investigation of the Bending Behavior in Silicon Nanowires: A Nanomechanical Modeling Perspective

Atomic Simulation of the Bending Deformation of A Single-Crystal Simply Supported Nano-Beam

Deformation and Bifurcation Analysis of Boron-Nitride Nanotubes

Elastic, elastic–plastic properties of Ag, Cu and Ni nanowires by the bending test using molecular dynamics simulations

Atomic mechanisms governing the elastic limit and the incipient plasticity of bending Si nanowires.

Measurement of young's modulus and residual stress of nanobeam using AFM

Porosity and Deformable Boundary Effects on the Dynamic of Nonlocal Sigmoid and Power-Law FG Nanobeams Embedded in the Winkler–Pasternak Medium

Comments on Nonlocal Effects in Nano-Cantilever Beams

On the Elastic Rod Models for Mechanical Tests of One-Dimensional Nanostructures under Transverse Loads