Abstract:Squeezing problems pose a serious challenge for tunnel engineers because they can slow down a project, increase the project budget, and potentially lead to catastrophic collapse. The choice of an adequate support is also often difficult owing to complex geological environments. Lack of sufficient understanding of geological conditions such as high geostress and horizontal layered rock mass could cause tunnel collapse and further lead to economic loss and endanger human life. In an attempt to deal with in-situ squeezing problem, this paper focus on the investigation of the mechanical behavior of tunneling in horizontal layered rock mass with high geostress and the proposal of proper engineering measures. A tunnel collapse incident occurred in northeastern China is analyzed using comprehensive methods including photographing, laboratory tests, discrete element numerical simulations, and site monitoring. The discrete element method was applied to investigate the tunneling mechanical behavior under high-geostress conditions in a horizontally layered rock mass. Numerical simulations show that the dominant horizontal stress and joints cause the maximum deformation at the corner of the arch region. The effect of horizontal joints and horizontal dominant stress were analyzed and found to be the main causes of the collapse. Based on the simulation results, an innovative, simple and efficient tangential yielding element is developed and implemented to test its applicability in a tunnel engineering scenario. Load-displacement curves of the tangential yielding element were obtained through laboratory tests and introduced to the numerical model using the 3D discrete element method. The performance of the developed tangential yielding element was validated in the simulation. Site monitoring was also conducted to determine the in-situ performance of the yielding support using the tangential yielding element. The monitored settlement at the crown region is in agreement with the simulation. The in-situ tests show that the yielding element was considerably deformed while the tunnel remained stable, which confirms the applicability of this technique. The effectiveness of the yielding element is also confirmed in terms of a comparative cost analysis of the yielding and resistant support schemes.

Investigating High-Strength Expanded Polystyrene (HS-EPS) as yielding support elements for tunnelling in squeezing ground conditions

Ground movement induced by parallel EPB tunnels in silty soils

Mechanical Performance of Polystyrene Foam (EPS): Experimental and Numerical Analysis

Investigating Steel Honeycomb Structure as Yielding Support Element for Tunnelling in Uneven Squeezing Ground

Design of the yielding support used highly deformable elements for a tunnel excavated in squeezing rock

Numerical evaluation of a yielding tunnel lining support system used in limiting large deformation in squeezing rock

Full-Scale Experimental Study on the Effect of Ground Surcharge on the Stress and Deformation of Shield Tunnels

Experimental Scrutiny of Uniaxial Compressive Stress–Strain Relationship for Expanded Polystyrene Concrete

Numerical Study on the Mechanical Behavior of Shotcrete Lining with Yielding Support in Large Deformation Tunnel

Full-scale Experimental and Structural Characterization Study of Shield Tunnel Reinforcement under Ground Stacking Loads

The deformation coordination-dominated design of yielding supports applied in large deformation tunnels

Stress-induced collapse in horizontally layered rock and a yielding support strategy: A case study

Dynamic failure process of expanded polystyrene particle lightweight soil under cyclic loading using discrete element method

Strength Development and Lateral Load Resisting Properties of Expanded Polystyrene Based Lightweight Concrete Panels

Preliminary Mechanical Evaluation of Grouting Concrete as a Protective Layer for Tunnelling

Experimental investigation on the load-bearing capacity and deformation behaviour of the composite lining with polyurethane compressible layer

A Unified Analytical Model for Undrained Compressibility Behavior of Foam-Conditioned Coarse-Grained Soils Based on Effective Stress Analysis

Dynamic properties of low-density expandable polystyrene concrete materials

A Review of the Studies on Soil-EPS Composites: Beads and Blocks

Investigation on lateral pressure on a sheet-pile wall with EPS layer supporting an expansive soil slope

Mechanical Behavior of Ultrahigh-Performance Concrete Tunnel Lining Segments