Abstract:The central diaphragm is often used to reduce the span to maintain the stability and safety of structure in the construction of large-span loess tunnel due to the structure complexities. In this paper, relying on the field monitoring and measurement for Wangcun tunnel in Huangling-Yan’an expressway expansion project, the crown settlement and horizontal convergence of primary support steel rib and central diaphragm steel rib during the construction are analyzed by the upper bench CD method. According to the internal force transfer, deformation coordination, and arch foot displacement between the two structures, the support system is regarded as the arch-beam fixed structure with three times of statically indeterminate and movable abutment under the loads, and the mechanical calculation model of sidewall steel rib and the central diaphragm structure bearing loads and deformation together is established. Finally, through the mechanical model mentioned above, the deformation characteristics of central diaphragm structure and the horizontal convergence in the upper bench of tunnel are calculated and analyzed. The research shows the following: (1) the accumulated settlement of sidewall steel rib in Part I is greater than that of the sidewall steel rib in Part II, and the accumulated settlement of each part at the support structure during the tunnel excavation is less than the reserved deformation of 150 mm specified in the tunnel excavation; (2) the settlement located at the waist and maximum excavation line position of central diaphragm is mainly affected by the excavation of Parts I and II in upper bench; (3) during the whole excavation process, the excavation of Part I and Part II has the greatest influence on the convergence at arch waist and the maximum excavation line position in Part I, and the convergence at the above two positions all experienced four stages of “convergence-expansion-convergence-gradual stability”; and (4) the errors between the horizontal convergence and the deformation of central diaphragm obtained by the mechanical model and the field monitoring data are between 12.7% and 27.5%. The calculated results are in good agreement with the actual situation. The research can provide a theoretical basis for the study of deformation and mechanical properties for support structure in the construction of large-span loess tunnel by the upper bench CD method.

The deformation coordination-dominated design of yielding supports applied in large deformation tunnels

Analysis of Influence of Deformation Modes of Retaining Structures on Deformation of a Side Shield Tunnel

A better understanding of tunnel deformable supports: from analytical model to engineering application

Study of Deformation Behaviors and Mechanical Properties of Central Diaphragm in a Large-Span Loess Tunnel by the Upper Bench CD Method

Numerical Study on the Mechanical Behavior of Shotcrete Lining with Yielding Support in Large Deformation Tunnel

Design of the yielding support used highly deformable elements for a tunnel excavated in squeezing rock

Experimental study on performance of spring damping support structure system for large deformation tunnel in soft rock

Full-Scale Experimental Study on the Effect of Ground Surcharge on the Stress and Deformation of Shield Tunnels

Analysis of Forces and Deformation Rule of Existing Shield Tunnel Caused by Ground-heaped Load

Deformation Behaviors and Mechanical Mechanisms of Double Primary Linings for Large-Span Tunnels in Squeezing Rock: A Case Study

Experiments and Numerical Simulation of the Reinforcement Effect of Channel-Steel-reinforced Shield Tunnel Segments under Unloading Conditions

Analytical computation of support characteristic curve for circumferential yielding lining in tunnel design

The Study for Longitudinal Deformation of Adjacent Shield Tunnel Due to Foundation Pit Excavation with Consideration of the Retaining Structure Deformation

Numerical evaluation of a yielding tunnel lining support system used in limiting large deformation in squeezing rock

Failure mechanism and control technology of large deformation for Muzhailing Tunnel in stratified rock masses

Research on the Mechanism of Loose Deformation in Weak Fracture Zone Tunnel Surrounding Rock and Support Control

Support scheme optimization aimed at the asymmetric deformation of the supported rock in a deep tunnel

Numerical Simulation of New Support Structure for High In-situ Stress Tunnel of Sichuan–Tibet Railway

Research on the deformation control of surrounding rock about large-section tunnel in strong-medium weathered slate

Decoupling Analysis of Interaction between Tunnel Surrounding Rock and Support in Xigeda Formation Strata

Analysis on deformation and structural safety of a novel concrete-filled steel tube support system in loess tunnel