Abstract:This paper focuses on the theoretical treatment of the laminar, incompressible, and time-dependent flow of a viscous fluid in a porous channel with orthogonally moving walls. Assuming uniform injection or suction at the porous walls, two cases are considered for which the opposing walls undergo either uniform or nonuniform motions. For the first case, we follow Dauenhauer and Majdalani [Phys. Fluids 15, 1485 (2003)] by taking the wall expansion ratio α to be time invariant and then proceed to reduce the Navier–Stokes equations into a fourth order ordinary differential equation with four boundary conditions. Using the homotopy analysis method (HAM), an optimized analytical procedure is developed that enables us to obtain highly accurate series approximations for each of the multiple solutions associated with this problem. By exploring wide ranges of the control parameters, our procedure allows us to identify dual or triple solutions that correspond to those reported by Zaturska et al. [Fluid Dyn. Res. 4, 151 (1988)]. Specifically, two new profiles are captured that are complementary to the type I solutions explored by Dauenhauer and Majdalani. In comparison to the type I motion, the so-called types II and III profiles involve steeper flow turning streamline curvatures and internal flow recirculation. The second and more general case that we consider allows the wall expansion ratio to vary with time. Under this assumption, the Navier–Stokes equations are transformed into an exact nonlinear partial differential equation that is solved analytically using the HAM procedure. In the process, both algebraic and exponential models are considered to describe the evolution of α(t) from an initial α0 to a final state α1. In either case, we find the time-dependent solutions to decay very rapidly to the extent of recovering the steady state behavior associated with the use of a constant wall expansion ratio. We then conclude that the time-dependent variation of the wall expansion ratio plays a secondary role that may be justifiably ignored.

Homogenization-based design of microstructured membranes: wake flows past permeable shells

Quasi-Linear Homogenization for Large-Inertia Laminar Transport across Permeable Membranes

Experimental investigation of flow around a circular cylinder with attached membranes

A Homogenization Approach for Turbulent Channel Flows over Porous Substrates: Formulation and Implementation of Effective Boundary Conditions

Rough or wiggly? Membrane topology and morphology for fouling control

A Unified, One Fluid Model for the Drag of Fluid and Solid Dispersals by Permeate Flux towards a Membrane Surface

Enhancing Stability and Performance of Flexible Membrane Structures in Wake Flows Through Jet Flow Control

On the boundary layer structure near a highly permeable porous interface

Suppression of von Kármán vortex streets past porous rectangular cylinders

How does porosity heterogeneity affect the transport properties of multibore filtration membranes?

Optimization of fluid flow in membrane chromatography devices using computational fluid dynamic simulations

Understanding flow dynamics in membrane distillation: Effects of reactor design on polarization

An isogeometric boundary element method for soft particles flowing in microfluidic channels

A Numerical Technique for Laminar Swirling Flow at the Interface Between Porous and Homogenous Fluid Domains

Unified non-equilibrium simulation methodology for flow through nanoporous carbon membrane

Stratified liquid-liquid flow through microchannels with grooved walls

Inverse Design of Pore Wall Chemistry To Control Solute Transport and Selectivity

Influence of Geometry Structures on the Transfer and Flow Characteristics of Membrane Modules

Homotopy Based Solutions of the Navier–Stokes Equations for a Porous Channel with Orthogonally Moving Walls

Tailoring porous media for controllable capillary flow

Fluid flow inside slit-shaped nanopores: the role of surface morphology at the molecular scale