Single DC-link-based 5-level MLI topology for renewable and grid applications with fewer switches
Anurag Tiwari,Ruchi Agarwal
DOI: https://doi.org/10.1007/s00202-023-02186-7
IF: 1.63
2024-01-11
Electrical Engineering
Abstract:This article describes a 5-level single DC source multilevel inverter (SDS-MLI) with fewer components and optimum efficiency. Multiple DC source MLI topologies are presently deemed unsuitable for a range of applications, such as renewable energy (RE) conversion systems and grid applications, while single DC source MLI topologies are more suitable. Existing MLI circuits have more active/passive components, but the SDS-MLI design employs a level-doubling network, requires fewer components, and reduces the DC-link voltage for grid applications. The SDS-MLI uses one capacitor, six switches, and a DC supply. A primary control method enforces a well-known phase disposition carrier arrangement to actualize the presented configuration. Existing systems are evaluated based on the number of active and passive components, their efficiency, capacitor voltage, and voltage stress. In comparison to existing topologies, SDS-MLI has fewer components, a lower capacitor voltage, and less TSVs to achieve an efficiency of 98.66%. MATLAB/Simulink and experimental setups are used to verify the SDS-MLI architecture. On the basis of experimental setup and simulation, the number of load voltage and load current waveforms under various situations such as variable load, varied input supply, different frequencies, and different modulation indexes are shown.
engineering, electrical & electronic