Abstract:Cracking of pavement materials affects the service performance of pavement structures. It is widely investigated by discrete element method (DEM) because the DEM can present the cracking behavior and mechanism from the mecroscopic perspective. However, improper calibration method is time-consuming and the simulation results are not applicable for different loading conditions. To address this issue, a systematical calibration method is proposed to establish a more reasonable DEM model, and it is used to explore the cracking behavior and mechanism for pavement materials. The fiber reinforced cement treated aggregates (F-CTA) used to construct the pavement base are selected as an example to elaborate the process. First, contacts within the F-CTA were divided into five groups according to physical components. Then, laboratory tests were performed to obtain macro mechanical properties including strength and modulus. Next, the corresponding virtual tests were established and the contact model parameters were calibrated from mono-component to mixture. This calibration method was validated by the three-point bending test incorporating all contact parameters obtained from the above calibrations and the process of cracking evolution was analyzed. Results show that the simulated mechanical responses and crack distribution based on the systematical calibration are in good agreement with laboratory measurements and observations, exhibiting well reliability for calibrating contact parameters of composite material. Young's modulus of the F-CTA is sensitive to the mecro effective modulus in the virtual indirect tensile test while Young's modulus and tensile strength are vulnerable to the mecro cohesion in the virtual uniaxial compression test. The mortar-aggregate and mortar-aggregate interface is relatively weak where cracks are prone to appear. The fibers can optimize the distribution of the crack network. The cracking evolution contains three stages and the second stage has a significant influence on the cracking behavior of the F-CTA.

Early-age cracking behavior of advanced reinforced concrete pavement under environmental loading

Finite element modeling of active cracking in actively reinforced concrete pavement slab exposed to fluctuating temperature

Automated Finite Element Modeling and Analysis of Cracked Reinforced Concrete Beams from Three Dimensional Point Cloud

INCORPORATING PRE-EXISTING CRACKS IN STRUCTURAL ASSESSMENT OF RC STRUCTURES

Transverse Crack Behavior in Continuously Reinforced Concrete Pavement with Basalt Fiber Reinforcement

Laboratory investigation on early-age shrinkage cracking behavior of partially continuous reinforced concrete pavement

Experimental Investigation on First Crack Strength and Crack Widthof Reinforced Concrete Beamsby Side-Bonding Cfrp Sheets

Reinforcement Design of Composite Pavement Continuously Reinforced with Basalt Fiber Reinforced Plastics Bars

Systematical Calibration and Validation of Discrete Element Models for Fiber Reinforced Cement Treated Aggregates

Full-scale field test of early-age behaviour of partially continuous reinforced concrete pavement

Analysis of the Load Stress of BFRP Continuously Reinforced Composite Pavement

Re-evaluation of continuously reinforced concrete pavement structural model

Field investigation of early-age behaviour of continuously reinforced concrete pavement with semi-rigid base

Predicting transverse crack properties in continuously reinforced concrete pavement

Evaluation and Improvement of the Current CRCP Pavement Design Method

Cracking Behavior of Cfrp Laminate-Strengthened Rc Beams with Premechanical and Postmechanical Environmental Damage

Development of a full-Scale approach to predict overlay reflective crack

Asphalt Layer Cracking Behavior and Thickness Control of Continuously Reinforced Concrete and Asphalt Concrete Composite Pavement

A Method for Evaluating CRCP Performance Based on Edge-Loaded FWD Test

Dynamic behaviours of continuously reinforced concrete pavement on a layered transversely isotropic saturated subgrade under moving loads