SURFACE FILMS AND PARTICLE SIZE DETERMINATION OF POWDERS

Vincent R. Gray
DOI: https://doi.org/10.1139/cjr50b-036
1950-06-01
Canadian Journal of Research
Abstract:It has been found possible to spread almost any powder on a water surface in a layer one particle thick and to study its surface pressure – area relation by conventional film balance techniques. A special sprinkler was developed for placing the powder on the surface, and flotation agents were adsorbed on particles which do not normally float. Fine particles needed extended outgassing and drying before they were sufficiently deflocculated. Although all films collapsed more or less readily on compression it was possible to define a point in the compression curve which represented a rigid film. The thickness of this film was a definite fraction of the mean particle diameter, measured by microscopic methods, the fraction varying with ease of agglomeration and with the shape of the particles. This method can be used for measurement of mean particle size and it possesses certain advantages over existing methods for many purposes.
What problem does this paper attempt to address?