Abstract:Results of multiyear research of zirconium materials from nuclear reactors show that the hydrogen content measured by a high-temperature extraction method does not always correlate with the number and size of zirconium hydrides measured by metallography. Additional examinations found that hydrogen is contained not only in the metal but also in the oxide film of samples under examination. This means that the level of hydrogenation of zirconium materials under irradiation should be estimated by the hydrogen content in metal only to allow for a correct comparison of the results of gas analysis and metallographic investigations. In this connection, the hydrogen content was measured separately in the metal and in the oxide film. A device to mechanically remove sediments and oxide film from samples was developed. However, when removing the oxide mechanically, a top layer of metal is also removed, as a rule, which leads to an uncontrolled increase in the measurement error because of a nonuniform distribution of hydrides in the metal. The assessment of the contribution of oxide hydrogen using a curve “total hydrogen content vs. oxide film thickness” showed no distinct dependence. Moreover, it was stated that the results of the total hydrogen content measurements by the high-temperature extraction method can be affected by the elementary composition of sediments and oxide films on the surfaces of spent items. The performed research resulted in the development of a technique to measure the hydrogen mass fraction by high-temperature extraction in an inert gas flow separately in the metal and oxide film without any preliminary mechanical removal of the oxide. This will allow examining the dependence between the hydrogen content in the oxide film and its thickness, as well as estimating a possible correlation between the hydrogen mass fraction in the metal and the quantitative characteristics of hydrides measured by a metallographic image.

Oxidation and hydrogenation of zirconium alloy E110 under electron and plasma irradiation in various conditions

Irradiation resistance of vacuum arc chromium coatings for zirconium alloy fuel claddings

Effect of Pulsed Electron Beam Treatment and Hydrogen on Properties of Zirconium Alloy

One-Chip Solution to Intelligent Robot Control: Implementing Hexapod Subsumption Architecture Using a Contemporary Microprocessor

Hydride Rim Formation in E110 Zirconium Alloy during Gas-Phase Hydrogenation

Effect of Impurity and Alloying Elements on the High-Temperature Oxidation Resistance of a E110 Zirconium Alloy

Study of Coatings Formed on Zirconium Alloy by Plasma Electrolytic Oxidation in Electrolyte with Submicron Yttria Powder Additives

Application of photo-electrochemical methods in investigation of oxidation zirconium and its alloys

Characterization and corrosion behavior of plasma electrolytic oxidation coating on zirconium alloy in superheated steam condition

Isothermal experiments on steam oxidation of magnetron-sputtered chromium-coated zirconium alloy cladding at 1200 °C

Irradiation simulation of zirconium using high energy argon implantation

Hydrogenation Behavior of Cr-Coated Resistance Upset Welds of E110 Zirconium Alloy

Rapid assessment of structural and compositional changes during early stages of zirconium alloy oxidation

Cr-coated Zr-4 alloy prepared by electroplating and its in situ He+ irradiation behavior

Microstructure and high-temperature oxidation behaviour of anti-oxidation coating on zirconium alloys: An overview

Effect of Isothermal Oxidation on the Structural Properties of (Ni,Pt)Al Coatings Doped with Zr at 1150 °C

Peculiarities of Application of the Gas Extraction Method for Determination of Hydrogen Content in Samples of Irradiated Zirconium Materials

Multi-Elemental Coatings on Zirconium Alloy for Corrosion Resistance Improvement

Long-Term Oxidation of Zirconium Alloy in Simulated Nuclear Reactor Primary Coolant—Experiments and Modeling

In-situ hydrogen charging of zirconium powder to study isothermal percipitation of hydrides and determination of Zr-hydride crystal structure

Thermal Oxidation Process of Micron Zirconium Powder