Abstract:The article is devoted to the study of wettability on combined textured surfaces (laser texturing): textured copper and graphene (Cu/G) synthesized on copper. For the first time the combined effect of various textures after laser texturing and graphene synthesis on corrosion current and wettability before and after corrosion is investigated. Previous research works have shown that the surface wettability after laser texturing varies greatly over time, from superhydrophilic to highly hydrophobic. However, the present work shows that the combined effect of laser texturing and graphene synthesis allows stabilizing the wettability of textured samples over time, as well as significantly reducing the impact of corrosion on the contact angle. The droplet contact angle changes slightly over time after corrosion. The smallest change in the contact angle corresponds to the Cu/G surface for textures with craters. At that, the corrosion current of the textured Cu/G sample is reduced 12–14 times, compared with the textured copper. The use of textures with craters provides higher corrosion resistance than in the case of textures without craters. The performed XPS analysis reveals that that the textured wall with craters has a maximum peak C = C (C1s XPS spectra). A new mechanism is proposed to explain the different wettability inversion period for textured copper with graphene synthesis. The wettability of textured surfaces is simulated using molecular dynamics methods. The contact angle of the nanodrop depends on both the textures and the hydrophilicity of the polished surface. The obtained results will be useful for the development of combined methods and composite materials in materials science to control wettability, stabilize surface properties, as well as to counteract aggressive environmental effects.

Influence of Annealing and Substrate Surface Textures on the Wettability of Graphene‐Coated Copper Foil

The influence of copper substrate temperature on the wettability of graphene coating

Evaporation of Water Droplets and Corrosion on Various Graphene Coatings

Co-use of laser texturing and graphene synthesis

Grain size effects on the wettability of as-grown graphene and dropwise condensation

Wetting transparency of graphene

Effects of thermal treatments on the hydrophobicity and anticorrosion properties of as-grown graphene coatings

Hydration and dewetting near graphite-CH(3) and graphite-COOH plates.

Effect of Airborne Contaminants on the Wettability of Supported Graphene and Graphite

The Influence of Temperature on Anisotropic Wettability Revealed by Friction Force Measurement

Wetting Properties Of Defective Graphene Oxide: A Molecular Simulation Study

Graphene coating- and electro-wetting strategy for micro/nanostructured surfaces

Temporal evolution of wetting transitions of graphene oxide coated on roughened polyvinyl chloride surfaces

The role of hydrogen partial pressure on the annealing of copper substrates for graphene CVD synthesis

Simulation Of Wettability Of Nanotextured Surfaces By Molecular Dynamics

Preparation of Ultra-Smooth Cu Surface for High-Quality Graphene Synthesis

Visualization of Graphene on Various Substrates Based on Water Wetting Behavior

Atomic Level Insight into Wetting and Structure of Ag Droplet on Graphene Coated Copper Substrate—Molecular Dynamics versus Experiment

Effect of Chemical Treatment and Thermal Annealing in N2 Atmosphere on Copper Foil Surface for Graphene Growth by Direct-Liquid-Injection Chemical Vapor Deposition Process

Influence of chemistry and topography on the wettability of copper

Study On The Surface Energy Of Graphene By Contact Angle Measurements