Abstract:To achieve high-quality friction stir welding (FSW) of the rocket fuel tank, experiments of FSW 18 mm thick 2219 aluminum alloy are carried out, the microstructure and mechanical properties of the joints are studied, and the influence law of the tool rotation speed on microstructure, microhardness and tensile strength of the welded joints are explored. The welding speed used in the experiment is 100 mm/min, and the tool rotation speed is 350 r/min, 400 r/min and 450 r/min, respectively. The microstructure of the weldments is analyzed by optical microscopy and scanning electron microscopy. The mechanical properties are measured by tensile tests and Brinell hardness, and it is found that the mechanical properties of the joint first increased and then decreased with the increase of the tool rotation speed. Due to the uneven temperature distribution along the thickness direction of the weldment, the crystal grains in the nugget zone (NZ) are small equiaxed crystals as a whole, with different local sizes and shapes. The size of the crystal grains seems relatively large in the upper layer and relatively small in the bottom layer. As the tool rotation speed increases, so does the heat generation, and thus, the size and degree of the deformation of the crystal grains increase. The defect appears when the tool rotation speed is 450r/min. As the tool rotation speed increases, the tensile strength and microhardness of the joints increase first and then decrease. The maximum tensile strength of the overall weld is 270 MPa. The microhardness shows a trend of ‘‘U’’ distribution, and the hardness in the NZ is slightly higher than that of thermos-mechanically affected zone (TMAZ) and heat-affected zone (HAZ). The fracture location of the joints is the NZ. The fracture mode is ductile fracture. There exist a large number of second phase particles Al 2 Cu in the dimples.

Research on friction stir welding technology for aluminum alloy tank of spacecraft

Welding Characteristics Analysis and Application on Spacecraft of Friction Stir Welded 2A14-T6 Aluminum Alloy

Research Status of Friction Stir Spot Welding Technology

Analysis of typical working conditions and experimental research of friction stir welding robot for aerospace applications

Numerical simulation and experimental research on friction stir welding of 2024-T3 aeronautical aluminum alloy

Experimental research and process parameter optimization of high-speed friction stir welding

Microstructure and properties of friction stir welding 6061 aluminum alloy joint

Study on the Microstructure and Mechanical Properties on Al/Carbon Fiber Reinforced Thermoplastic Dissimilar Friction Stir Lap Welding Joints

Friction Stir Welding Process of 01420 Aluminum-Lithium Alloy

Review on Research Status of Friction Stir Welding Technology

Analysis of Friction Stir Welded Joint Properties of 2A12 Aluminum Alloy

Recent Advances in Friction Stir Welding/Processing of Aluminum Alloys: Microstructural Evolution and Mechanical Properties

Application of Friction Stir Welding in the Aluminum ShipBuilding

Research on the mechanical properties and fracture mechanism of ultrasonic vibration enhanced friction stir welded aluminum/steel joint

Microstructure and mechanical properties of FSW medium thickness 2219 aluminum alloy

A Feasibility Research on Friction Stir Welding of a New-Typed Lap–butt Joint of Dissimilar Al Alloys

Insight on Corrosion Behavior of Friction Stir Welded AA2219/AA2195 Joints in Astronautical Engineering

The study on defects in aluminum 2219-T6 thick butt friction stir welds with the application of multiple non-destructive testing methods

In-situ Formed Amorphous Phase in Aluminum/steel Friction Stir Welds: Interface Evolution and Strength Improvement

Microstructure and mechanical properties of friction stir welded powder metallurgy AA2024 alloy

Mechanical properties and welding parameters window of friction stir welding