Abstract:Abstract This paper describes a multidisciplinary design optimization for performance improvement of an electric-ducted fan rotor using free-form deformation (FFD) and data mining techniques. A practical partitioning approach for FFD parameterization was applied in combination with engineering design parameters to optimize the fan rotor. Regression analysis was used to initially determine an approximation function for the blade static stress and subsequently integrated into a fully coupled iterative loop to optimize the blade considering two operating points. Two optimization solutions for 10 and 12 blades were performed. Percentage improvements in the efficiency of 1.05% and 1.32% were realized for 10 and 12 blades, respectively, at near peak efficiency flowrate. Also, blade static stress was reduced by percentages of 5.49% and 12.37% for 10 and 12 blades compared with the baseline. Data mining results revealed key design variable sensitivities where blade twist, sweep, chord, and hub thickness distribution were found to be the most influential for 12 blades while for 10 blades, blade lean, sweep and chord at the midspan and tip. The optimized blades were found to have a significant increase in chord from midspan to tip mimicking a wide chord fan blade particularly for 10 blades. Analysis of the flow field revealed that the axial velocity from 0.4 to 0.8 spanwise length increased significantly for the optimum blades due to the increase in blade twist and chord length at all stable operating points. However, the leakage trajectory relative to the blade chord was observed to be larger and interacted with the trailing edge wake flow downstream for the optimum blades at near-stall conditions. Furthermore, the increase in chord length and the thinning of the blade close to the trailing edge from 0.4 to 0.8 span reduced the suction-side blade loading and static stress.

Experimentation of multi directional fan blade model using fused deposition modeling process

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Optimization and Experimental Investigation of 3D Printed Micro Wind Turbine Blade Made of PLA Material

Multidisciplinary Design Optimization for Performance Improvement of an Axial Flow Fan Using Free-Form Deformation

Material Behaviour of Three Blade Propeller Using Metal Additive Manufacturing Techniques

Abrasive flow finishing of 3D-Printed Aerofoils: Design, numerical Simulation, and experimental analysis

An innovative multilayered material fabricated through additive manufacturing for structural applications: method and mechanical properties

Wind Tunnel Testing and Validation of Helicopter Rotor Blades Using Additive Manufacturing

Parametric study on the aerodynamic performance of a ducted-fan rotor using free-form method

Effects of Single-arc Blade Profile Length on the Performance of a Forward Multiblade Fan

Optimization of fused deposition modeling parameters to fabricate morphogenesis light weight structure with high tensile and compression strength

Coupling bionic design and application of flow curved surface for carbon fiber composite fan blade

Performance Analysis of PLA Material Based Micro-Turbines for Low Wind Speed Applications

Integrated computational modeling of large format additive manufacturing: Developing a digital twin for material extrusion with carbon fiber-reinforced acrylonitrile butadiene styrene

3-D Modeling of Axial Fans

Mechanical Properties and Assessment of PLA Mixed with Carbon by Using Additive Manufacturing

DESIGN AND ANALYSIS OF COMPOSITE PROPELLER BLADE FOR AIRCRAFT

Mechanical characteristics and failure morphology of FFF-printed poly lactic acid composites reinforced with carbon fibre, graphene and MWCNTs

Structural Optimization of a Large-Scale 3D-Printed High-Altitude Propeller Blade with Experimental Validation

Suitableness of SLM Manufactured Turbine Blade for Aerodynamical Tests

Investigation of Fused Deposition Modelling Process Parameters in 3D Printing for Composite Material (Poly Lactic Acid and Banana Fibre)