Abstract:Thin-walled structures are widely used as crucial structural components for energy absorbing applications. To design lightweight thin-walled-involved composite structures with better mechanical performance remains an open issue. In this study, the X-shaped rib-reinforced foam-filled tubes were designed and tested under quasi-static axial compression. Two types of foams, i.e., the aluminum foam and the additively manufactured polylactide (PLA) foam were considered as lightweight fillers. The effects of foam block filling ratio (rib angle) and arrangement of different foam fillers on the axial crushing performance of the diagonally rib-reinforced foam block-filled tube were analyzed. Results indicated that tubes that were diagonally filled with PLA foam blocks possessed better energy absorption capacity, whereas the higher mean crushing strength was achieved by diagonally filling with two aluminum blocks. It also revealed that tubes filled with different foam blocks did not always show advantages over those filled with the same foams. Moreover, the diagonally aluminum foam blocks filled tubes with a large rib angle could induce the global buckling, whereas that with the rib angle of 120 degrees exhibited better mechanical properties in load consistency and specific energy absorption capacity. Numerical simulations were conducted to reveal the energy absorption enhancement mechanism of the tubes filled with varying combinations of the reinforced fillers. Results indicated that the interaction between the foam blocks and the reinforced rib contributed most to the increased energy absorption. Further, an analytical model for evaluating the crushing strength of the developed structure was proposed. The theoretical predictions are in good agreement with the experimental results. The idea of tailoring the fillers arrangement and assembling pattern would promote the development of optimal energy-absorbing thin-walled involved composite structures.

An Investigation on Axial Deformation Behavior of Thin-Wall Unfilled and Filled Tube with Aluminum Alloy (Al-Si7Mg) Foam Reinforced with SiC Particles

Compression behaviour and crashworthiness analysis of aluminum foam filled corrugated and tapered tubes with graded thickness

Energy-absorbing mechanism and crashworthiness performance of thin-walled tubes diagonally filled with rib-reinforced foam blocks under axial crushing

Experimental study on the crashworthiness of bio-inspired aluminum foam-filled tubes under axial compression loading

Axial Impact Performances of Composite Aluminum Foam Tubes

Crashworthiness study of aluminum foam-filled tubular lattice structures based on triply periodic minimal surface metamaterials under lateral crushing

Deformation and energy absorption properties of cenosphere/aluminum syntactic foam-filled circular tubes under lateral quasi-static compression

Enhanced energy absorption and microstructural studies on hollow glass microsphere filled closed cell aluminum matrix syntactic foam

Investigating the Mechanical Behavior and Energy Absorption Characteristics of Empty and Foam-Filled Glass/Epoxy Composite Sections under Lateral Indentation

Enhancement in the Mechanical Properties of Newly Developed Ceramic Reinforced Al-Based Syntactic Foams: Analysis of Microstructure, Mechanical Response, and Energy Absorption Properties

Deformation and energy absorption properties of cenosphere-aluminum syntactic foam-filled tubes under axial compression

Crushing Response of Al 7005 and 7075 Tubes against Transverse Loading

Influence of Extruded Tubing and Foam-Filler Material Pairing on the Energy Absorption of Composite AA6061/PVC Structures

Energy-absorbing properties of thin-walled square tubes filled with hollow spheres

Investigation on microstructures, compressive properties and energy absorption capacity of carbon nanotubes/aluminum composite foam-filled tubes

Energy absorption characteristics of a foam-filled tri-tube under axial quasi-static loading: experiment and numerical simulation

Axial crushing of self-lock multi-cell tubes with foam filler and tube envelope

Experimental Investigation of the Dynamic Responses of Thin-Walled and Foam-Filled Steel Tubes Subjected to Repeated Impacts

Quasi-static Deformation Mechanism and Compressive Properties of Aluminum Foams Fabricated by Friction Stir Processing

Modeling of Macro-Deformation Behavior of Thin-Walled Aluminum Foam by Gas Injection Method

A Preliminary Study on Adhesion on Steel Cylinder Filled with Aluminum Foam