Abstract:Power consumption is becoming worse with every technology generation. While there has been much research in recent years proposing design methods addressing this issue, one of the most efficient approaches is to reduce supply voltage, which can help mitigate both dynamic and static power consumption. In our research, we found the optimal voltage (Vmin) for energy efficiency in CMOS technology. We analyzed the different factors affecting Vmin and find that Vmin usually lies in subthreshold voltage regime. The increased sensitivity of subthreshold switching current to process variation poses a significant design challenge. We investigated the impact of subthreshold variation on circuit performance and energy consumption in a statistical manner and proposed certain design guidelines to mitigate variation.To verify the high energy efficiency of subthreshold operation, we designed and fabricated two subthreshold processors in 0.13um technology, specifically, the Subliminal 1 and Subliminal 2 processors. Measurements confirm 2.60pJ per instruction efficiency for the Subliminal 1. However, we also found that the on-chip SRAM was the energy consumption bottleneck. Therefore, we designed the first sub-200mV compact 6-T SRAM. It was fabricated in a commercial 0.13um CMOS technology and silicon measurements shows that all 24 dies measured were fully functional and a typical die operates from 1.2V to 193mV. This could be further extended to sub-170mV with 2% bit redundancy.The downside of voltage scaling into subthreshold is the considerable performance loss. To address this issue, we proposed a novel micro-architecture that combines chip multi-processing and subthreshold techniques. By tuning the supply voltage and threshold voltage of the L1 cache and the processor core independently, we found that having multiple cores sharing one faster local L1 provides the best energy efficiency. In particular, SPLASH2 benchmarks show about a 53% energy improvement over the traditional CMP approach (about 70% over a single core machine).

Modeling and implementation of a fully-digital integrated per-core voltage regulation system in a 28nm high performance 64-bit processor

Power Reduction Through Measurement and Modeling of Users and CPUs: Summary

Silicon-Validated Power Delivery Modeling and Analysis on a 32-Nm DDR I/O Interface.

A Silicon-Validated Methodology for Power Delivery Modeling and Simulation

User- and Process-Driven Dynamic Voltage and Frequency Scaling.

A Multicore Chip Load Model for PDN Analysis Considering Voltage–Current-Timing Interdependency and Operation Mode Transitions

Power Regulation in High Performance Multicore Processors

Performance-Aware Power Management in Embedded Controllers with Multiple-Voltage Processors

A 0.79 pJ/K-Gate, 83% Efficient Unified Core and Voltage Regulator Architecture for Sub/Near-Threshold Operation in 130 nm CMOS

A Dual-rail Based Dynamic Voltage and Frequency Scaling for Wide-Voltage-Range Processor

Negative Design Margin Realization through Deep Path Activity Detection Combined with Dynamic Voltage Scaling in a 55 nm Near-Threshold 32-Bit Microcontroller

Characterizing Power Delivery Systems with On/off-Chip Voltage Regulators for Many-Core Processors

Fully Digitally Controlled Voltage Regulator Based on FPGA

A Dual Core Oxide 8T SRAM Cell with Low Vccmin and Dual Voltage Supplies in 45nm Triple Gate Oxide and Multi Vt CMOS for Very High Performance Yet Low Leakage Mobile SoC Applications

A System-Level Voltage/Frequency Scaling Characterization Framework for Multicore CPUs

Investigation of Candidate VRM Topologies for Future Microprocessors

A New Thermal-Conscious System-Level Methodology for Energy-Efficient Processor Voltage Selection

Microprocessor Power Management Integration by Vrb-Cpu Approach

Ultra-low power processor design using sub-threshold design techniques

Research on Digital Control Chip for Voltage Regulator Modules

ReVIVaL: A Variation-Tolerant Architecture Using Voltage Interpolation and Variable Latency