Effects of the quality of pre-consolidated materials on the mechanical properties and morphology of thermoplastic pultruded flat laminates
Kirill Minchenkov,Alexander Vedernikov,Yulia Kuzminova,Sergey Gusev,Artem Sulimov,Artem Gulyaev,Anastasia Kreslavskaya,Ilya Prosyanoy,Guijun Xian,Iskander Akhatov,Alexander Safonov
DOI: https://doi.org/10.1016/j.coco.2022.101281
IF: 8
2022-01-01
Composites Communications
Abstract:Pre-consolidated tapes in thermoplastic pultrusion solve the problem of impregnating a reinforcement with high -viscosity thermoplastic resins. Thermoplastic glass fiber/polypropylene flat laminates (75 mm x 3.5 mm) were fabricated using pre-consolidated tapes from different manufacturers: pre-consolidated tapes by the ApATeCh-Tape Company (Russia) and pre-consolidated sheets by the Zhongji Company (China). In spite of the equal reinforcement volume fraction (38%), the laminates fabricated from the pre-consolidated sheets exhibited higher compressive, tensile, and flexural strengths than those made from the pre-consolidated tapes, differing by 27.1%, 27.3%, and 19.8%, respectively. The observed difference between the strength characteristics of the studied flat laminates was explained by the presence of unimpregnated regions in the fiber bundles and by matrix cracks in the pre-consolidated tapes, absent in the pre-consolidated sheets, as revealed by the scanning electron micro-scopy analysis. Such defects cannot be corrected during the pultrusion process, resulting in the formation of matrix cracks and debonding, impairing the mechanical performance of the produced pultruded laminates. Pre -consolidated sheets enable pultrusion flat laminates with larger cross-sections, exhibiting better mechanical performance and surface roughness, compared with thermoplastic pultruded composites fabricated from pre -consolidated tapes described in the literature.