Abstract:Nanocomposites based on polyolefin elastomer (POE), cyclic olefin copolymer (COC) and multi‐walled carbon nanotubes (MWCNTs) synthesized. By increasing the percentage of (MWCNT) in the POE/COC blend physical properties and electrical the conductivity increased. MWCNT has a greater tendency to be in the POE phase than COC. The subject of this research is a relatively detailed investigation of the rheological, morphological and electrical properties of nanocomposites based on polyolefin elastomer (POE), cyclic olefin copolymer (COC) and multi‐walled carbon nanotubes (MWCNTs). To formulate a mixture of two polymers (COC and POE), the melt mixing method was used and their morphology was studied by SEM technique and it was found that the morphology is of co‐continuous type. When the weight percentage ratio of COC was between 40 and 60, the desired morphology (co‐continuous) appeared. Interfacial tension calculations and TEM images proved that the nanotube particles were stabilized both within the phase of POE as well as at the interface of the two polymer phases. The rheological behavior was analyzed for composite samples containing 0–3 wt % MWCNT. The electrical and rheological percolation thresholds appeared at 1 and a 0.5 percent by weight of nanotube particles, respectively, which may be better to consider as related to the phenomenon of dual percolation. The highest conductivity was obtained for the nanocomposite containing 3% MWCNT. The results of mechanical tests also showed a strong upward trend of properties due to the addition of nanotube. Highlights The effect of COC content on the morphology of POE/COC blend was investigated. The Morphology for the POE/COC blend at low COC content was droplet‐matrix type. MWCNT has a greater tendency to be in the POE phase than COC. Rheological behavior strongly depended on the amount of nanotube particles. The highest conductivity was obtained for the sample containing 3% MWCNT.

Multiwalled carbon nanotubes@octavinyl polyhedral oligomeric silsesquioxanes nanocomposite preparation via cross-linking reaction in acidic media

Nanocomposites of Poly(vinylidene Fluoride) with Multiwalled Carbon Nanotubes

Preparation of Isotactic Polypropylene-Grafted Multiwalled Carbon Nanotubes (Ipp-G-mwnts) by Macroradical Addition in Solution and the Properties of Ipp-G-Mwnts/Ipp Composites

Functionalization of multi-walled carbon nanotubes with non-reactive polymers through an ozone-mediated process for the preparation of a wide range of high performance polymer/carbon nanotube composites

Preparation of Multiwall Carbon Nanotubes/poly(p‐phenylene Benzobisoxazole) Nanocomposites and Analysis of Their Physical Properties

Effective Approaches for the Preparation of Organo-Modified Multi-Walled Carbon Nanotubes and the Corresponding MWCNT/polymer Nanocomposites

Multi-walled Carbon Nanotubes-Poly (P-Phenylene-2,6-benzoxazole) Nanocomposites Prepared by In-Situ Polymerization Process

Preparation and Properties of Poly(2,5-benzoxazole)/Multi-walled Carbon Nanotube Composites

Preparation and Properties of Cyclic Olefin Copolymers Multiwalled Carbon Nanotube Nanocomposites

PPTA-oligomer Functionalized Multiwalled Carbon Nanotubes Synthesized by "One-Pot" Method for Reinforcement of Polyvinyl Chloride

SOLUBILITY IMPROVEMENT AND SURFACE FUNCTIONALIZATION OF MULTI-WALLED CARBON NANOTUBES BY A THIOL-FUNCTIONALIZED POLY(PHENYLACETYLENE) DERIVATIVE

Covalent Functionalization of Carbon Nanotubes with Polyhedral Oligomeric Silsequioxane for Superhydrophobicity and Flame Retardancy

Functionalization of multi-wall carbon nanotubes with silane and its reinforcement on polypropylene composites

Synthesis and Characterization of Multi-Walled Carbon Nanotube/Polythiophene Composites

In Situ Preparation and Continuous Fiber Spinning of Poly(P-Phenylene Benzobisoxazole) Composites with Oligo-Hydroxyamide-Functionalized Multi-Walled Carbon Nanotubes

Formation of a Carbon Fiber/polyhedral Oligomeric Silsesquioxane/carbon Nanotube Hybrid Reinforcement and Its Effect on the Interfacial Properties of Carbon Fiber/epoxy Composites

Poly(2,6-dimethyl-1,4-phenylene Oxide) (PPO) Multi-Bonded Carbon Nanotube (CNT): Preparation and Formation of PPO/CNT Nanocomposites

In Situ Synthesis and Characterization of Poly(2,5-Benzoxazole)/multiwalled Carbon Nanotubes Composites

Microstructure and Properties of Multiwalled Carbon Nanotubes/poly (P-Phenylene Benzobisoxazole) Composites

Polyolefin elastomer/cyclic olefin copolymer/multi‐walled carbon nanotubes nanocomposites: Rheological, morphological, electrical and mechanical study

Effect of Multi-Walled Carbon Nanotubes on the Properties of Polyoxymethylene