Abstract:The accurate measurement of aerosol particles and clusters smaller than 3 nm in diameter is crucial for the understanding of new particle formation processes. The particle counters used for measuring these particles are typically calibrated with metal or salt particles under dry conditions, which does not always represent the field conditions where these instruments are later used. In this study, we calibrated the All nano Condensation Nucleus Counter (nCNC), consisting of the PSM (Particle Size Magnifier) and a laminar flow butanol based CPC (Condensational Particle Counter), with well-defined biogenic oxidation products from beta-caryophyllene oxidation and compared it to a calibration with tungsten oxide under the same conditions. The organic particles were detected less efficiently than the inorganic ones. This resulted in a higher cut-off size for beta-caryophyllene oxidation products than for tungsten oxide. At the same PSM settings, the cut-off size for tungsten oxide was 1.2 nm and for beta-caryophyllene oxidation products 1.9 nm. However, repeating the calibration of the biogenic particles at 13% relative humidity at 31 degrees C, increased their detection efficiency in the PSM, increasing the cut-off diameter to 1.6 nm. Additionally, we present a comparison of the ion concentrations measured with the PSM and the NAIS (Neutral Cluster and Air Ion Spectrometer) during new particle formation experiments in the CLOUD (Cosmics Leaving Outdoors Droplets) chamber. In these experiments, we produced particles from different organic precursors, such as alpha-pinene, beta-caryophyllene and isoprene, as well as iodine. This way, we could determine the shift in cut-off diameter of the PSM for several different atmospherically relevant chemical compounds and compare it to the laboratory calibrations. We saw a diameter shift for the organic precursors of +0.3 nm in the PSM compared to the NAIS. These two approaches agreed well with each other and show that it is important to know the chemical composition of the measured particles to determine the exact size distribution using a supersaturation scanning method.

Modification and laboratory evaluation of a TSI ultrafine condensation particle counter (Model 3776) for airborne measurements

Laboratory Evaluation of a TSI Condensation Particle Counter (Model 3771) Under Airborne Measurement Conditions

Characteristics of Scanning Flow Condensation Particle Counter (SFCPC): A Rapid Approach for Retrieving Hygroscopicity and Chemical Composition of Sub-10 Nm Aerosol Particles

On Operation of the Ultra-Fine Water-Based CPC TSI 3786 and Comparison with Other TSI Models (TSI 3776, TSI 3772, TSI 3025, TSI 3010, TSI 3007)

A Simple and Inexpensive Dilution System for the Tsi 3007 Condensation Particle Counter

Nanometer Particle Detection by the Condensation Particle Counter UF-02proto

Sub-3nm Particle Detection with Commercial TSI 3772 and Airmodus A20 Fine Condensation Particle Counters

Sub-3 nm Particle Detection with Commercial TSI 3772 and Airmodus A20 Fine Condensation Particle Counters

Scanning Supersaturation Condensation Particle Counter Applied As a Nano-Ccn Counter for Size-Resolved Analysis of the Hygroscopicity and Chemical Composition of Nanoparticles

Quantifying the Effects of Operational Parameters on the Counting Efficiency of A Condensation Particle Counter Using Response Surface Design of Experiments (Doe)

Experimental Investigation of a Condensation Particle Counter Challenged by Particles with Varying Wettability to Working Liquid

Particle counting efficiencies of new TSI condensation particle counters

Detection Efficiency of a Water-Based TSI Condensation Particle Counter 3785

Calibration of a TSI Model 3025 Ultrafine Condensation Particle Counter

B3010: a boosted TSI 3010 condensation particle counter for airborne studies

Characterization of Three New Condensation Particle Counters for Sub-3 Nm Particle Detection: ADI Versatile Water CPC, TSI 3777 Nano Enhancer and Boosted TSI 3010

Facility for calibration of optical and condensation particle counters based on a turbulent aerosol mixing tube and a reference optical particle counter.

Measurement of Sub-3 Nm Flame-Generated Particles Using Butanol CPCs in Boosted Conditions

Improving Particle Detection Effi Ciency of a Condensation Particle Counter by Means of Pulse Height Analysis

Numerical simulation on the effects of flow parameters on the detection performance of a self-developed condensation particle counter

Activation of Sub-3 Nm Organic Particles in the Particle Size Magnifier Using Humid and Dry Conditions