Abstract:It is common practice to describe the coordination of metal atoms in a binding configuration with their nearest neighbors in terms of oxidation state, a measure by which the number of electrons redistributed between atoms forming chemical bonds. In XPS terms, change to an oxidation state is commonly inferred by correlating photoemission signal with binding energy. The assumption, when classifying photoemission signals into distinct spectral shapes, is that a distribution of intensities shifted to lower binding energy is evidence of a reduction in oxidation state. In this Insight note, we raise the prospect that changes in photoemission peak shape may occur without obvious changes, determined by XPS in stoichiometry for a material. It is well known that TiO 2 measured by XPS yields reproducible Ti 2p photoemission peaks. However, on exposing TiO 2 to ion beams, Ti 2p photoemission evolves to complex distributions in intensity, which are particularly difficult to analyze by traditional fitting of bell‐shaped curves to these data. For these reasons, in this Insight note, a thin film of TiO 2 deposited on a silicon substrate is chosen for analysis by XPS and linear algebraic techniques. Alterations in spectral shapes created from modified TiO 2 , which might be interpreted as the change in oxidation state, are assessed in terms of relative proportions of titanium to oxygen. It is found through detailed analysis of spectra that quantification by XPS, using procedures routinely used in practice, is not in accord with the typical interpretations of photoemission shapes. The data processing methods used and results presented in this work are of particular relevance to elucidating fundamental phenomena governing the surface evolution of materials‐enabled energy processes where cyclic/non‐steady usage changes the nature of bonding, especially in the presence of contaminants.

Surface chemistry of the titanium powder studied by XPS using internal standard reference

Surface Analysis Insight Note: Observations relating to photoemission peak shapes, oxidation state, and chemistry of titanium oxide films

Surface characterization of titanium-based implant materials

Towards an atomic-scale understanding of oxide film in the Ti powder surface

Determination of metal impurities in titanium dioxide using slurry sample introduction by axial viewing inductively coupled plasma optical emission spectrometry

Surface treatment of titanium alloys for the x-ray diffraction study

Roughness Analysis of Powder-Bed Fused Nickel–Titanium Surfaces with Chemical Etching Enhancement by a Safe Aqueous Fluoride Solution

Surface chemistry in Ti-6Al-4V feedstock as influenced by powder reuse in electron beam additive manufacturing

SEM, EDS and XPS Analysis of the Coatings Obtained on Titanium after Plasma Electrolytic Oxidation in Electrolytes Containing Copper Nitrate

Influence of Titanium Surface Porosity on Adhesive Strength of Coatings Containing Calcium Silicate

XPS characterisation of surface modified Ni-Ti shape memory alloy

Three-dimensional particle size, shape, and internal porosity characterization: Application to five similar titanium alloy (Ti–6Al–4V) powders and comparison to two-dimensional measurements

Direct analysis of titanium dioxide solid powder by fluorination assisted electrothermal vaporization inductively coupled plasma atomic emission spectrometry

XPS Analysis of Submicrometer Barium Titanate Powder

Photoemission Fingerprints for Structural Identification of Titanium Dioxide Surfaces

Aiming at low-oxygen titanium powder: A review

Surface Modification and Tribological Performance of Calcium Phosphate Coatings with TiO2 Nanoparticles on VT1-0 Titanium by Micro-Arc Oxidation

Synthesis of Titanium-Based Powders from Titanium Oxy-Sulfate Using Ultrasonic Spray Pyrolysis Method

Determination of trace elements in titanium oxides by wavelength dispersive x‐ray fluorescence spectrometry (WD‐XRF)

Titanium dioxide (TiO2) Nanoparticles XRD Analyses: An Insight

Investigation on Quick Surface Metallization of Nano Titania Powder