Abstract:Immersion lithography seeks to extend the resolution of optical lithography by filling the gap between the final optical element and the wafer with a liquid characterized by a high index of refraction. The semiconductor industry demands high throughput, leading to relatively large wafer scanning velocities and accelerations. For higher scanning velocities, an issue that has been identified is the deposition of the immersion liquid while confining a relatively small amount of liquid to the under-lens region. Liquid loss occurs at the receding contact line that forms when a substrate is withdrawn from a liquid, which potentially leads to defects on printed patterns. There has been substantial prior work relative to understanding and building semi-empirical correlations and numerical models to investigate this behavior of the receding three-phase contact line. In the current work, a new liquid injection and collection model with analytic solutions is presented and compared with experimental results, in which the critical velocity for liquid loss is mainly a function of the vacuum degree, the injection flow rate, the properties of the immersion liquid. This correlation allows the critical velocity to be predicted with a given gap height between wafer and lens using only a measurement of the injection speed and knowledge of the fluid properties. Experimentally, glycerin-water mixtures of varying viscosities and different injection flow rates were tested, with variable outlet vacuum degree and inlet speed, showing a mean average error within 12%. This correlation represents a useful tool that can serve to approximately guide the development of fluid control for immersion systems as well as to evaluate alternative immersion fluid candidates to minimize liquid deposition while maximizing throughput.

Effects of dwell time of excitation waveform on meniscus movements for a tubular piezoelectric print-head: experiments and model

Mathematical Modelling of One-Dimensional Piezoelectric Transducers Based on Monoclinic Crystals

Droplet Jetting of Piezoelectric Printhead and Corresponding Effect Factors

Higher-order meniscus oscillations driven by flow-focusing leading to bubble pinch off and entrainment in a piezo acoustic inkjet nozzle

Design and Fabrication of A Piezoelectric Bend Mode Drop-On-Demand Inkjet Printhead with Interchangeable Nozzle

Effect of upper surface characteristics on meniscus stability in immersion flow field

Selective Evaporation at the Nozzle Exit in Piezoacoustic Inkjet Printing

Axisymmetric thermo-mechanical analysis of laser-driven non-contact transfer printing

Electric Field-Assisted Droplet Formation Using Piezoactuation-Based Drop-On-Demand Inkjet Printing

Deformation characteristics of a single droplet driven by a piezoelectric nozzle of the drop-on-demand inkjet system

Influences of Excitation on Dynamic Characteristics of Piezoelectric Micro-Jets

An Accurate Thermomechanical Model for Laser-Driven Microtransfer Printing

Reduction Of Droplet Volume By Controlling Actuating Waveforms In Inkjet Printing For Micro-Pattern Formation

Drop-on-demand (DOD) inkjet dynamics of printing viscoelastic conductive ink

Actuation waveform auto-design of drop-on-demand inkjet for ejection droplet without satellite

Resonance behavior of a compliant piezo-driven inkjet channel with an entrained microbubble

Thermo-mechanical Modeling of Laser-Driven Non-Contact Transfer Printing: Two-Dimensional Analysis

Optimizing dispensing performance of needle-type piezoelectric jet dispensers: A novel drive waveform approach

Mechanisms of inkjet printing in a liquid environment

Investigation on the critical velocity for liquid loss in immersion lithography

Lumped-Parameter Modeling For Meniscus Dynamic Analysis In Immersion Flow Field