Abstract:Systematic errors induced by distortions in the pump pulse of conventional Brillouin distributed fiber sensors are thoroughly investigated. Experimental results, supported by a theoretical analysis, demonstrate that the two probe sidebands in standard Brillouin optical time-domain analyzers provide a non-zero net gain on the pump pulse, inducing severe distortions of the pump when scanning the pump-probe frequency offset, especially at high probe power levels. Compared to the impact of non-local effects reported in the state-of-the-art, measurements here indicate that for probe powers in the mW range (below the onset of amplified spontaneous Brillouin scattering), the obtained gain and loss spectra show two strong side-lobes that lead to significant strain/temperature errors. This phenomenon is not related to the well-known spectral hole burning resulting from pump depletion, but it is strictly related to the temporal and spectral distortions that the pump pulse experiences when scanning the Brillouin gain/loss spectrum. As a solution to this problem, a novel scanning scheme for Brillouin sensing is proposed. The method relies on a fixed frequency separation between the two probe sidebands, so that a flat zero net gain is achieved on the pump pulse when scanning the pump-probe frequency offset. The proposed technique is experimentally validated, demonstrating its ability to completely cancel out non-local effects up to a probe power ultimately limited by the onset of amplified spontaneous Brillouin scattering. The method allows for one order of magnitude improvement in the figure-of-merit of optimized long-range Brillouin distributed fiber sensors, enabling measurements along a 100 km-long sensing fiber with 2 m spatial resolution and with no need of added features for performance enhancement.

Reducing the impact of relative intensity noise via phase-based measurement in Raman-assisted Brillouin optical time domain analysis

Relative intensity noise reduction with fiber ring resonator

Efficient Demodulation of Brillouin Phase Spectra and Performance Enhancement in BOTDA Incorporating Phase Noise Elimination

Non-local effect in Brillouin optical time-domain analyzer based on Raman amplification

Enhanced Sensing Performance in Long Distance Brillouin Optical Time-Domain Analyzer Based on Raman Amplification: Theoretical and Experimental Investigation

Theoretical Investigations on the Non-Local Effect in A Long-Distance Brillouin Optical Time-Domain Analyzer Based on Bi-Directional Raman Amplification

Influence of Optical Simple Pulse Coding on the Brillouin Optical Time Domain Analyzer Based on Bi-Directional Raman Amplification

Brillouin Optical Time Domain Analyzer Based on Bi-Directional Raman Amplification

Noise reduction in the surface plasmon resonance array sensor

Reduction of relative intensity noise in a broadband source-driven RFOG using a high-frequency modulation technique

Efficient two-stage strain/temperature measurement method for BOTDA system based on Bayesian uncertainty quantification

Brillouin Optical Time Domain Analysis System Based on Raman Amplification and Semiconductor Optical Amplifier

Optimization of long-range BOTDA sensors with high resolution using first-order bi-directional Raman amplification

Vector Brillouin optical time-domain analysis with Raman amplification and optical pulse coding

Effect of linewidth on intensity noise induced by stimulated Brillouin scattering in single-mode fibers

Performance Enhancement in a Few-Mode Rayleigh-Brillouin Optical Time Domain Analysis System Using Pulse Coding and LMD Algorithm

Dynamic Strain Sensing by Using Phase-Gain Ratio in Slope-Assisted Brillouin Optical Time Domain Analysis

Pump-to-Stokes relative intensity noise transfer in Brillouin amplifiers

Measurement Accuracy Improvement of Brillouin Signal Using Wavelet Denoising Method

Reduction of relative intensity noise in a diamond Raman laser

Novel scanning method for distortion-free BOTDA measurements