Preparation of CoCrFeMnNi-based high-entropy/aluminide laminated composites: Multielement interdiffusion reactions

Yu Wang,Xiangfei Peng,Wenjuan Zhao,Hong Xu,Bin Liu,Hongkui Mao

DOI: https://doi.org/10.1016/j.jallcom.2023.171606

IF: 6.2

2023-08-04

Journal of Alloys and Compounds

Abstract:CoCrFeMnNi-based high-entropy/aluminide laminate (HAL) composites were produced following the hot pressing diffusion sintering method. The microstructure of the samples was analyzed using the SEM, EDS, and EBSD techniques, and the results revealed that the diffusion reaction phases of the HAL composite consisted of a four-layer aluminide structure based on the Al 13 (Cr, Mn, Fe, Co, Ni) 4 phase. The diffusion behavior of iron dominated the resulting phase, leading to the formation of Fe-Al compounds. Under the influence of the hysteresis diffusion effect of high entropy alloys, Al 13 (Cr, Mn, Fe, Co, Ni) 4 phase layers (ASL I–III) with different grain sizes and growth orientations are formed due to the difference of diffusion rates at different interfaces. At the front end of the diffusion reaction, the aggregation layer of the secondary phase Al 9 (Fe, Co, Ni) 2 appears due to the segregation of Co and Ni elements. The growth kinetics model of HAL composites was explored, and it was observed that a mixture diffusion type controlled the growth of the aluminide layer via 'grain boundary and lattice diffusion'. The mechanical properties and failure modes of the HAL composites were investigated through quasi-static and dynamic mechanical tests. The fracture toughness reached 25 MPa·m 1/2 , and the main energy dissipation modes were the deformation of the ductile layer and the fracture of the hard, brittle layer. The dynamic impact failure modes were primarily deformation and 45% adiabatic shear bands, and the impact strength and energy consumption reached up to 1800 MPa and 2260 J/mm 3 . HAL composites with high alumina content exhibited prominent crack propagation and fragmentation properties under high-speed impact. The stress wave was significantly attenuated in the crushed aluminide layer, which significantly improved the energy absorption effect of aluminide.

materials science, multidisciplinary,chemistry, physical,metallurgy & metallurgical engineering