Abstract:Sodium hypochlorite (NaClO) is widely used for the chemical cleaning of fouled ultrafiltration (UF) membranes. Various studies performed on polymeric membranes demonstrate that long-term (>100 h) exposure to NaClO deteriorates the physicochemical properties of the membranes, leading to reduced performance and service life. However, the effect of NaClO cleaning on ceramic membranes, particularly the number of cleaning cycles they can undergo to alleviate irreversible fouling, remains poorly understood. Silicon carbide (SiC) membranes have garnered widespread attention for water and wastewater treatment, but their chemical stability in NaClO has not been studied. Low-pressure chemical vapor deposition (LP-CVD) provides a simple and economical route to prepare/modify ceramic membranes. As such, LP-CVD facilitates the preparation of SiC membranes: (a) in a single step; and (b) at much lower temperatures (700–900 °C) in comparison with sol-gel methods (ca. 2000 °C). In this work, SiC ultrafiltration (UF) membranes were prepared via LP-CVD at two different deposition temperatures and pressures. Subsequently, their chemical stability in NaClO was investigated over 200 h of aging. Afterward, the properties and performance of as-prepared SiC UF membranes were evaluated before and after aging to determine the optimal deposition conditions. Our results indicate that the SiC UF membrane prepared via LP-CVD at 860 °C and 100 mTorr exhibited excellent resistance to NaClO aging, while the membrane prepared at 750 °C and 600 mTorr significantly deteriorated. These findings not only highlight a novel preparation route for SiC membranes in a single step via LP-CVD, but also provide new insights about the careful selection of LP-CVD conditions for SiC membranes to ensure their long-term performance and robustness under harsh chemical cleaning conditions.

What problem does this paper attempt to address?

### Problems the Paper Attempts to Solve This paper aims to investigate the effects of long-term use of sodium hypochlorite (NaClO) cleaning on silicon carbide (SiC) ultrafiltration membranes prepared by low-pressure chemical vapor deposition (LP-CVD). Specifically, the paper focuses on the following points: 1. **Effects of Long-term Exposure to NaClO**: Although NaClO is widely used for cleaning fouled ultrafiltration membranes, long-term exposure (over 100 hours) to NaClO can lead to the deterioration of the physicochemical properties of polymer membranes, thereby reducing their performance and lifespan. However, little is known about the chemical stability of ceramic membranes, especially SiC membranes, in NaClO and the number of cleaning cycles they can withstand. 2. **Optimization of SiC Membranes Prepared by LP-CVD**: SiC membranes can be prepared in one step at relatively low temperatures (700-900°C) using the LP-CVD method, whereas traditional sol-gel methods require high temperatures up to 2000°C. The paper explores the effects of different deposition conditions (temperature and pressure) on the performance of SiC membranes to determine the optimal preparation conditions. 3. **Evaluation of Chemical Stability**: By aging SiC membranes in a 5% NaClO solution for 200 hours to simulate long-term use conditions, the chemical stability of SiC membranes is evaluated. The study includes changes in surface chemical composition, surface morphology, pore size, and water flux. ### Main Findings 1. **Effects of Different Deposition Conditions**: SiC membranes prepared at 860°C and 100 mTorr exhibited excellent resistance to NaClO aging, whereas SiC membranes prepared at 750°C and 600 mTorr significantly degraded. 2. **Morphological Changes**: SEM observations revealed that the surface of SiC-7 membranes formed discontinuous SiC nodules, while the surface of SiC-8 membranes formed a continuous dense SiC layer. This explains the differences in water flux between the two. 3. **Chemical Stability**: XPS analysis indicated that SiC membranes maintained their chemical composition after NaClO aging, but changes in surface morphology and pore size were observed. SiC-8 membranes showed better chemical stability after aging. ### Conclusion This study not only proposes a new method for preparing SiC membranes in one step using LP-CVD but also provides new insights into selecting appropriate LP-CVD conditions to ensure the long-term performance and robustness of SiC membranes under harsh chemical cleaning conditions.

Effect of Long-Term Sodium Hypochlorite Cleaning on Silicon Carbide Ultrafiltration Membranes Prepared via Low-Pressure Chemical Vapor Deposition

Highly permeable silicon carbide-alumina ultrafiltration membranes for oil-in-water filtration produced with low-pressure chemical vapor deposition

Unveiling the Impacts of Sodium Hypochlorite on the Characteristics and Fouling Behaviors of Different Commercial Polyvinylidene Fluoride Hollow Fiber Membranes

Chemical cleaning reagent of sodium hypochlorite eroding polyvinylidene fluoride ultrafiltration membranes: Aging pathway, performance decay and molecular mechanism

Compact SiOC Ceramic Composite Nanofiltration Membranes by Slow Dip Coating for Water Purification

Lower-temperature preparation of SiC ceramic membrane using zeolite residue as sintering aid for oil-in-water separation

Ceramic Processing of Silicon Carbide Membranes with the Aid of Aluminum Nitrate Nonahydrate: Preparation, Characterization, and Performance

Impacts of Sodium Hydroxide and Sodium Hypochlorite Aging on Polyvinylidene Fluoride Membranes Fabricated with Different Methods

Effect of NaClO and NaOH at Low Agent Concentration on the Ageing of PVDF Ultrafiltration Membrane

Silicon carbide ceramic membrane support sintered at 800 °C with low-temperature sintering aid

SiO2 Modification of Silicon Carbide Membrane via an Interfacial In Situ Sol–Gel Process for Improved Filtration Performance

In Situ-Grown Al2O3 Nanoflowers and Hydrophobic Modification Enable Superhydrophobic SiC Ceramic Membranes for Membrane Distillation

Aging of PVDF and PES ultrafiltration membranes by sodium hypochlorite: Effect of solution pH

Effects of Organic Fouling and Cleaning on the Retention of Pharmaceutically Active Compounds by Ceramic Nanofiltration Membranes

Zirconia ultrafiltration membranes on silicon carbide substrate: microstructure and water flux

Sodium hypochlorite assisted membrane cleaning: Alterations in the characteristics of organic foulants and membrane permeability

Oil-in-water emulsion separation: Fouling of alumina membranes with and without a silicon carbide deposition in constant flux filtration mode

Preparation of α-alumina/γ-alumina/γ-alumina-titania ceramic composite membrane for chloride ion removal

A comparison study: The different impacts of sodium hypochlorite on PVDF and PSF ultrafiltration (UF) membranes

Further understanding NaClO cleaning of bacteria-fouled ultrafiltration membrane: Variation of membrane structure and formation of halogenated by-products

Effective and low-toxicity: A membrane cleaning method using peroxymonosulfate catalytic chlorination