Abstract:In recent years, perovskite solar cell (PSC) has achieved power conversion efficiency as high as over 20 %, making it competitive with high-efficiency thin film solar cells such as CuInGaSe and CdTe solar cells. However, the critical issue of reliability and stability for PSC should be addressed since a significant degradation of photovoltaic (PV) performance at low temperature has been found regardless of planar mesoporous PSC. To reveal the degradation of PV performance in PSC, the temperature-dependent PV performance of the planar PSC is investigated in detail. A PSC sample is loaded into a cryostat chamber connected to a compressor and illuminated by a halogen lamp. The operating temperature varies from 200 K to 325 K and the current-voltage (J-V) characteristic of planar PSC is measured at different scan rates from 10 V/s to 0.0017 V/s. At a fast scan rate of 10 V/s, the PSC shows a low PV performance at either low temperature or high temperature. The short-circuit current (J(SC)), open-circuit voltage (V-OC) and maximum power point (P-MPP) are found to decline with the temperature decrteasing. Moreover, the J-V curve also shows the S-shape characteristic. This suggests that the inefficient transport of photo-generated carriers occurs in the PSC. Ions such as Pb2+, CH3NH(3+) and I-vacancies cause the screening effect of built-in field and the photo-generated carriers cannot be separated nor collected efficiently. As a result, J(SC) and V-OC show small values in J-V curves measured at a fast scan rate. However, the degradation in PV performance is temporary. The PV performance gradually reaches a steady state at different operating temperatures with scan rate going down to 0.0017 V/s. The P-MPP and V-OC increase with temperature decreasing. These results indicate that a long illumination time is necessary for PSC to reach a steady state. After long-time illumination under biased condition (i.e., J-V curves measured at slow scan rate), the built-in field is compensated for by the external bias and the ions piling in the interface regions have enough time to diffuse towards the opposite direction. Thus, the screening effect of built-in field is reduced and the PV performance of PSC reaches a steady state. According to the result of device simulation, the increasing V-OC at low temperature is attributed to the enhanced built-in potential difference and the reduced recombination rate of carriers. The temperature-dependent external quantum efficiency measurements of planar PSC before and after light illuminationis are performed to investigate the mechanism of carrier transport. It reveals that the separation and collection efficiencies of photo-generated carriers can be improved significantly after light illumination due to the fact that the screening effect of built-in field is reduced. These findings help understand the carrier transport mechanism in planar PSC.

Temperature Modes and Mechanical Stresses in Photovoltaic Converters of Concentrated Sunlight

Thermal Management of Solar Photovoltaic Systems

Dark and illuminated J(V) characteristics of thin layered bulk heterojunction P3HT:PCBM sandwich solar cells after thermal treatment

Microchannel cooling of concentrator photovoltaics: A review

Thermal Management of Photovoltaics Using Porous Nanochannels

Light concentration solar cell: temperature proper and dynamic effects on electrical parameters determined by using J-V and P-V characteristics

An Experimental and Numerical Investigation of Photovoltaic Module Temperature Under Varying Environmental Conditions

Thermomechanical stress in solar cells: Contact pad modeling and reliability analysis

Thermal Management of Conventional Photovoltaic Module Using Phase Change Materials—an Experimental Investigation

A Multiscale-Multiphysics Integrated Model to Investigate the Coupling Effects of Non-Uniform Illumination on Concentrated Photovoltaic System with Nanostructured Front Surface

The Effects of Temperature on Photovoltaic and Different Mitigation Techniques: A Review

Experimentally thermal management of low-concentrated photovoltaic via new configurations of dimple/trapezoidal heat spreaders of different sizes

Temperature-Dependent Time Response Characteristic of Photovoltaic Performance in Planar Heterojunction Perovskite Solar Cell

Thermal Management of PV Based on Latent Energy Storage of Composite Phase Change Material: A System-Level Analysis with Pore-Scale Model

Comprehensive Study and Optimization of Concentrated Photovoltaic-Thermoelectric Considering All Contact Resistances

Thermal Management of Ultra High Concentrator Photovoltaic Cells: Analysing the Impact of Sintered Porous Media Microchannel Heat Sinks

Microstress for Metal Halide Perovskites Solar Cells: From Source to Influence and Management

THERMAL OPERATING CONDITIONS OF THE HYBRID PHOTOMODULE WITH ANY EXPENSE OF THE HEAT CARRIER

Transient and Non-Uniform Heat Flux Effect on Solar Thermoelectric Generator with Phase Change Material

Investigation of Focusing Properties of Photovoltaic Module Concentrator in a Wide Temperature Range

The State of the Art of Photovoltaic Module Cooling Techniques and Performance Assessment Methods