The stability of ferroelectric polarization of PVDF upon irradiation

U. Giegerich,J. Wust,B.-J. Jungnickel
DOI: https://doi.org/10.1109/94.848915
IF: 2.509
2000-06-01
IEEE Transactions on Dielectrics and Electrical Insulation
Abstract:Polymeric actuator and sensor materials suffer from a low thermal and temporal stability. We report on an attempt to slow down the underlying structural relaxation in polyvinylidenefluoride (PVDF) films by irradiation with electrons of 1.5 MeV. This treatment yielded a dose-dependent crosslinking of the macromolecular chains. It caused a considerable rise of the ferroelectric remanent and saturation polarization, and the material became a harder ferroelectric. These changes were almost completely and irreversibly lost upon subsequent annealing. Electron spin resonance (ESR) measurements revealed that a large number of radicals and trapped electrons remained after irradiation (/spl sim/1 per crystallite), and that the electric conductivity increased from 0.11 pS/m in the un-irradiated but poled sample to 1.1 pS/m at 450 kGy. The increase in conductivity with dose is caused completely by a corresponding increase of the product /spl mu/n of the charge carrier mobility /spl mu/ and the number density n. Based on a discussion of depolarization effects, we conclude that the change in ferroelectric behavior upon irradiation is caused mainly by the activity of those charges which are implanted or created by irradiation, and that the majority of them are annihilated by thermal treatment. However, the reduction of polarization with time, or at elevated temperature, is considerably slowed down due to the existence of crosslinks.
engineering, electrical & electronic,physics, applied
What problem does this paper attempt to address?