Abstract:Thermal flooding by steam injection was a traditional method for exploiting heavy oil. The produced liquid was a highly stable water-in-oil or oil-in-water emulsion in several oilfields. In this work, we focused on studying the effect of high temperature on the stability of an emulsion system involving two typical crude oils (heavy crude oil and light crude oil) and brine. It was impossible to directly measure the interfacial viscoelastic modulus because of the high viscosity of the heavy oil. In order to solve this problem and analyze the contribution of those fractions to the formation of stable emulsions, the heavy crude oil was divided into three cuts: remaining fraction, resin, and asphaltene. The model oils were prepared from the mixture of several heavy crude oil fractions with kerosene:xylene (1:1 v/v) to investigate the high-temperature behaviors of their emulsions. The stability was evaluated through a high-temperature–high-pressure (HTHP) visual pressure–volume–temperature cell, and a temperature up to 200 °C was achieved. The automatic pendant drop technique was used to analyze the interfacial rheology of model oils/brine system under HTHP conditions. With increasing formation temperature, the kinetically stable heavy oil emulsion had a much higher viscosity. The stabilities of heavy crude oil and light crude oil emulsions had opposite trends as the formation temperature increased. The stabilities of different model oils indicated that the mass fraction of asphaltene was responsible for the stability of emulsions at high temperature. With increasing temperature, the interfacial viscoelastic properties stabilized by 4.0 wt % asphaltenes had an increasing trend, but the stability of remaining fraction, resin, and 0.4 wt % asphaltene had a decreasing trend. The mechanism of formation of a stable and more rigid interfacial film was revealed by the effect of high temperature on asphaltene aggregation and water molecules.

The Stability of O/W type emulsions as functions of temperature and the HLB of emulsifiers: The emulsification by PIT-method

The stability of W/O type emulsions as a function of temperature and of the hydrophilic chain length of the emulsifier

Factors Affecting the Phase-Inversion Temperature of Fatty Alcohol Ethoxylates

Phase Inversion Temperature (PIT) Emulsification Process

Factors affecting emulsion stability, and the HLB concept

Stability mechanisms of liquid water-in-oil emulsions

A Simple and Effective Test Method of the Emulsion Stability

The effect of NaCl and Na2SO4 concentration in aqueous phase on the phase inversion temperature O/W nanoemulsions

Mechanism of High Stability of Water-in-Oil Emulsions at High Temperature

Stability studies of high-stable water-in-oil model emulsions

Study on the HLB Rule for Nonionic Surfactant

Preparation of stable multiple emulsions using food-grade emulsifiers: evaluating the effects of emulsifier concentration, W/O phase ratio, and emulsification process

Highly Concentrated Water-in-Oil Emulsions: Influence of Electrolyte on Their Properties and Stability

Polyols, High Pressure, and Refractive Indices Equalization for Improved Stability of W/O Emulsions for Food Applications

The effect of total amount of emulsifiers on the optimum HLB in the system of Span80-Tween-rapeseed oil-water

Influence of Surfactant Structure on the Stability of Water-in-Oil Emulsions under High-Temperature High-Salinity Conditions

Interfacial Cooperative Assembly of Surfactants and Opposite Wettability Nanoparticles Stabilizes Water-in-Oil Emulsions at High Temperature

Stability Analysis of Pure Oil-Water Emulsion in Gravity-Based Separators

Study on the relationships between the oil HLB value and emulsion stabilization

Destabilization of a model O/W/O double emulsion: From bulk to interface