A. L. Kritcher,A. B. Zylstra,C. R. Weber,O. A. Hurricane,D. A. Callahan,D. S. Clark,L. Divol,D. E. Hinkel,K. Humbird,O. Jones,J. D. Lindl,S. Maclaren,D. J. Strozzi,C. V. Young,A. Allen,B. Bachmann,K. L. Baker,T. Braun,G. Brunton,D. T. Casey,T. Chapman,C. Choate,E. Dewald,J.-M. G. Di Nicola,M. J. Edwards,S. Haan,T. Fehrenbach,M. Hohenberger,E. Kur,B. Kustowski,C. Kong,O. L. Landen,D. Larson,B. J. MacGowan,M. Marinak,M. Millot,A. Nikroo,R. Nora,A. Pak,P. K. Patel,J. E. Ralph,M. Ratledge,M. S. Rubery,D. J. Schlossberg,S. M. Sepke,M. Stadermann,T. I. Suratwala,R. Tommasini,R. Town,B. Woodworth,B. Van Wonterghem,C. Wild

Abstract:In this work we present the design of the first controlled fusion laboratory experiment to reach target gain G>1 N221204 (5 December 2022) [ Phys. Rev. Lett. 132 , 065102 (2024)], performed at the National Ignition Facility, where the fusion energy produced (3.15 MJ) exceeded the amount of laser energy required to drive the target (2.05 MJ). Following the demonstration of ignition according to the Lawson criterion N210808, experiments were impacted by nonideal experimental fielding conditions, such as increased (known) target defects that seeded hydrodynamic instabilities or unintentional low-mode asymmetries from nonuniformities in the target or laser delivery, which led to reduced fusion yields less than 1 MJ. This Letter details design changes, including using an extended higher-energy laser pulse to drive a thicker high-density carbon (also known as diamond) capsule, that led to increased fusion energy output compared to N210808 as well as improved robustness for achieving high fusion energies (greater than 1 MJ) in the presence of significant low-mode asymmetries. For this design, the burnup fraction of the deuterium and tritium (DT) fuel was increased (approximately 4% fuel burnup and a target gain of approximately 1.5 compared to approximately 2% fuel burnup and target gain approximately 0.7 for N210808) as a result of increased total (DT plus capsule) areal density at maximum compression compared to N210808. Radiation-hydrodynamic simulations of this design predicted achieving target gain greater than 1 and also the magnitude of increase in fusion energy produced compared to N210808. The plasma conditions and hotspot power balance (fusion power produced vs input power and power losses) using these simulations are presented. Since the drafting of this manuscript, the results of this paper have been replicated and exceeded (N230729) in this design, together with a higher-quality diamond capsule, setting a new record of approximately 3.88MJ of fusion energy and fusion energy target gain of approximately 1.9. https://doi.org/10.1103/PhysRevE.109.025204 ©2024 American Physical Society

Demonstration of a hydrodynamically equivalent burning plasma in direct-drive inertial confinement fusion

Demonstration of hot-spot fuel gain exceeding unity in direct-drive inertial confinement fusion implosions

Burning plasma achieved in inertial fusion

Toward a burning plasma state using diamond ablator inertially confined fusion (ICF) implosions on the National Ignition Facility (NIF)

Diagnosing Inertial Confinement Fusion Ignition

Design of an inertial fusion experiment exceeding the Lawson criterion for ignition

Experimental Demonstration of Low Laser-Plasma Instabilities in Gas-Filled Spherical Hohlraums at Laser Injection Angle Designed for Ignition Target

Energy Principles of Scientific Breakeven in an Inertial Fusion Experiment

Progress Towards Ignition on the National Ignition Facility

The impact of low-mode symmetry on inertial fusion energy output in the burning plasma state

The Experimental Plan for Cryogenic Layered Target Implosions on the National Ignition Facility-The Inertial Confinement Approach to Fusion

Magnetized Fast Isochoric Laser Heating for Efficient Creation of Ultra-High-Energy-Density States

Study of Ultra-Intense Laser Propagation in Overdense Plasmas for Fast Ignition

Experimental demonstration of particle energy, conversion efficiency and spectral shape required for ion-based fast ignition

Investigation of laser plasma instabilities driven by 527 nm laser pulses relevant for direct drive inertial confinement fusion

Design of the first fusion experiment to achieve target energy gain

Observations and properties of the first laboratory fusion experiment to exceed a target gain of unity

Nonlinear Force Driven Plasma Blocks Igniting Solid Density Hydrogen Boron: Laser Fusion Energy Without Radioactivity

Kinetic Simulations of Nuclear Burning Plasmas in Inertial Confinement Fusions Taking into Account the Large-Angle Collisions

Studies of laser-plasma interaction physics with low-density targets for direct-drive inertial confinement schemes

Present understanding of ignition and Gain using indirect-drive inertial confinement fusion target designs on the U.S. National Ignition Facility