Investigation of laser plasma instabilities driven by 527 nm laser pulses relevant for direct drive inertial confinement fusion

F. Wasser,Ş. Zähter,M. Rivers,S. Atzeni,F. P. Condamine,G. Cristoforetti,G. Fauvel,N. Fischer,L. A. Gizzi,D. Hoffmann,P. Koester,T. Laštovička,J. F. Myatt,R. L. Singh,M. Sokol,W. Theobald,S. Weber,T. Ditmire,T. Forner,M. Roth
DOI: https://doi.org/10.1063/5.0188693
IF: 2.2
2024-02-01
Physics of Plasmas
Abstract:We report on a study of laser plasma instabilities with 527 nm laser pulses in an intensity range of 0.5×1013−1.1×1015 Wcm−2 and plasma parameters entering a regime that is relevant for direct drive inertial confinement fusion. Using the kilojoule high repetition rate L4n laser at the Extreme Light Infrastructure—Beamlines, more than 1300 shots were collected, and the onset and the growth of stimulated Brioullin scattering (SBS) and stimulated Raman scattering (SRS) were studied with a high confidence level. The measured onset intensities are 0.2×1014 Wcm−2 for SBS and 1.4×1014 Wcm−2 for SRS. At the maximum intensity, the total fraction of backscattered energy reaches 2.5% for SBS and 0.1% for SRS. These results are of high relevance for advanced concepts for inertial fusion energy, which rely on the use of 527 nm laser light to drive the implosion of the fuel target, and in particular, they can be used as a benchmark for advanced simulations.
physics, fluids & plasmas
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the occurrence and development of laser - plasma instabilities (LPIs) when using 527 - nanometer laser pulses in direct - drive inertial confinement fusion (ICF). Specifically, the study focuses on the onset and growth characteristics of stimulated Brillouin scattering (SBS) and stimulated Raman scattering (SRS) under 527 - nanometer laser pulses within a specific intensity range. These instabilities have important impacts on laser energy coupling efficiency, illumination uniformity, and hot - electron preheating in the ICF process. Therefore, understanding their behavior is crucial for optimizing ICF experimental design and improving the commercial feasibility of fusion energy. The paper has collected more than 1,300 data points through high - repetition - rate experiments at the Extreme Light Infrastructure - Beamlines (ELI - Beamlines) and has studied in detail the performance of SBS and SRS at different laser intensities. The experimental results not only fill the gap in ICF - related LPI data for 527 - nanometer lasers but also provide an important reference benchmark for more advanced inertial fusion energy concepts in the future. In particular, the study has found that even when the density gradient length is approximately 200 micrometers, when the laser intensity reaches \(1\times10^{14}\text{ to }1\times10^{15}\text{ W/cm}^2\), the thresholds of SBS and SRS will also be exceeded, which emphasizes the importance of considering LPI mitigation techniques, such as increasing the laser bandwidth. Future research plans will further explore the impact of broadband - spectrum laser pulses on LPI.