Abstract:(A) Illustration of the crystallagraphic orientation of STO single crystal and the mechanical rolling direction. (B) SEM imagine taken at the center of the plastic deformation zone of STO single crystal after 100x cyclic rolling under F = 10 N. It has long been known that dislocations can be used to tune the functional and mechanical properties of ceramics. However, introducing dislocations with controllable networks and densities into ceramics is difficult. In this study, a mechanical rolling technique was proposed to introduce dislocations into ceramics. Using a hard SiC ball with a diameter of 5 mm as a roller, plastic zones and dislocations were successfully produced in a SrTiO3 (STO) single crystal. The plastic zone area and dislocation densities were determined by the applied force (F) and number of rolling cycles. A force of 10 N produced a scalable plastic zone with an area of 140 μm × 5000 μm without crack formation after 100 rolling cycles. The dislocation density at the center of the plastic deformation zone can reach ∼1014 m2, which is an order of magnitude higher than that achieved previously by others. Increasing the applied force increased the density of the introduced dislocations, for example, ∼2 × 1014 m−2 under F = 30 and 35 N, however, lead to crack nucleation in the sample. The dislocations introduced significantly enhanced the mechanical properties of the STO crystal. The measured Vickers' hardness and fracture toughness increased by 55%–60% and 23%–24%, respectively, compared to the crystal before rolling. This method can serve as a robust technique for engineering dislocations in ceramics, fulfilling the requirements of dislocation‐tuned mechanical and functional investigations.

Near‐surface plastic deformation in polycrystalline SrTiO3 via room‐temperature cyclic Brinell indentation

Extreme dislocation-mediated plasticity of yttria-stabilized zirconia

Introducing dislocations in ceramics by mechanical rolling: A first demonstration using SrTiO3 crystal

Theoretical insights into the Peierls plasticity in SrTiO3 ceramics via dislocation remodelling

Engineering dislocation‐rich plastic zones in ceramics via room‐temperature scratching

Theoretical insights into the Peierls plasticity in SrTiO 3 ceramics via dislocation remodelling

Understanding the Role of 1/2 ⟨110⟩ Dislocations in Deformation Mechanisms of Single-Crystal High-Entropy Carbide Ceramics from Machine Learning Force Field Simulations

Low-Temperature In Situ Large Strain Plasticity Of Ceramic Sic Nanowires And Its Atomic-Scale Mechanism

Achieving room temperature plasticity in brittle ceramics through elevated temperature preloading

Simulation of microplasticity-induced deformation in uniaxially strained ceramics by 3-D Voronoi polycrystal modeling

Anisotropic Plasticity of Nanocrystalline Ti:A Molecular Dynamics Simulation

Micro-Scale Plastic Deformation of Polycrystalline Ti3sic2 under Room-Temperature Compression

Influence of dislocations on thermal conductivity of strontium titanate

Plastic deformation in nanocrystalline TiN at ultra-low stress: An in situ nanoindentation study

In-situ High-Temperature Micromechanical Behavior of Flash-Sintered Strontium Titanate

Harvesting room-temperature plasticity in ceramics by mechanically seeded dislocations

Damage-tolerant oxides by imprint of an ultra-high dislocation density

The nature of deformation-induced dislocations in SrTiO3: Insights from atomistic simulations

Structural Properties of Plastically Deformed SrTiO3 and KTaO3

Room-temperature bulk plasticity and tunable dislocation densities in KTaO3

Nondestructive Investigation of Microstructures and Defects at a SrTiO3 Bicrystal Boundary