Abstract:Monitoring the physical and chemical processes that develop between cement and water during hydration is essential for ensuring the practicality and suitability of cement for different applications. The objective of this paper is to present a comparative analysis of very early-age hydration process (VEAHP) of Limestone Calcined Clay Cement (LC3) vs. conventional and blended cement pastes using an embedded piezo sensor (EPS) based on electro-mechanical impedance (EMI) technique. Experiments were conducted on LC3, Fly-ash (FA) blended cement, and Ordinary Portland cement (OPC) paste specimens embedded with a lead zirconate titanate patch to acquire the conductance signatures during the VEAHP. The spectral features, mineral constituents, and surface morphology of the different cement pastes are assessed using Fourier transformation infrared, X-ray diffraction, and Scanning electron microscopic tests. Further, an equivalent stiffness parameter was extracted from the acquired raw EMI signatures during VEAHP to understand the changes in the mechanical properties. The experimental results revealed that there were differences in the setting times of OPC, LC3 and FA pastes, and the most suitable indicator for monitoring was the variation in amplitude of the resonance peak and frequency shift determined from the EMI signatures. Specifically, the LC3 paste showed a higher percentage variation in frequency due to its shorter initial and final setting times compared to the OPC and FA pastes. Additionally, the equivalent stiffness gain calculated from the EMI signature followed an increasing trend during the liquid and semi-solid stages of the hydration process in all cement pastes, with LC3 exhibiting a higher value compared to OPC and FA.

Investigation of the hydration properties of cement with EDTA by alternative current impedance spectroscopy

Investigation of the Filling-Overflow Behavior of Corrosion Products in Reinforced Mortar

Effect of disodium EDTA on hydration and mechanical properties of calcium sulphoaluminate-belite cement

Optimizing Cement Content in Controlled Low-Strength Soils: Effects of Water Content and Hydration Time

Nondestructive Monitoring Hydration of Belite Calcium Sulfoaluminate Cement by EIS Measurement

Non-Destructive Monitoring of Hydration Characteristics in Alternative Materials and Seawater-Based Cementitious Pastes Using Electrochemical Impedance Spectroscopy

Monitoring the hydration behavior of hardened cement paste affected by different environmental pH regimes

Experimental study on the capillary absorption of cement-based materials and analysis of influencing factors

Tracing the early and long-term hydration of fast setting cementitious material (Ca7ZrAl6O18) and calcium aluminate cement (CAC) pastes by means of electrochemical impedance spectroscopy and other methods

THE EFFECT OF DIFFERENT ELECTROLYZED WATER ON PROPERTIES AND HYDRATION REACTION OF MORTAR

Critical Features of Microstructure Development of Early-Age Cement Paste Revealed by Non-Contact Electrical Resistivity Measurement

An efficient method for determining the pozzolanic reaction degrees of low-calcium supplementary cementitious materials in blended cement pastes

Development of cementitious capillary crystalline waterproofing agents and durability study of concrete in the presence of chloride with sulfate in aqueous environment

The Effect of Ethylene Diamine Tetra(Methylene Phosphonic Acid) Sodium on the Hydration of Tricalcium Silicate at 80 °C

Development of different alkaline electrolysed water on early-strength enhancement and hydration acceleration of cement-based materials

Early-age characterisation of Portland cement by impedance spectroscopy

Influence of Triethanolamine on Elemental Concentrations in Aqueous Phase of Hydrating Cement Pastes

Characterizing the Influencing Factors in a Novel Repairing Material for Concrete Structures by AC Impedance Spectroscopy

Comparative analysis of very-early age hydration process: LC3 vs. conventional and blended cement pastes using embedded piezo sensors

Ultrasonic monitoring of hydration behavior of cement paste doped with triethanolamine using novel piezoelectric ultrasonic transducer

Effects of filler type and aging on self-sensing capacity of cement paste using eddy current-based nondestructive detection