Abstract:Organic photovoltaics (OPVs) have been considered as one of the preliminary candidates for the third-generation solar cells due to their particularly advantages, such as light-weight, low cost, solution processability and mechanical flexibility. In recent years, the power conversion efficiency (PCE) of OPVs has achieved remarkable progress with the development of non-fullerene acceptors (NFAs), which exhibit stronger capability of light absorption and stability than the fullerene acceptors. However, the narrow absorption properties of organic materials still restrict the further breakthrough of the performance of OPVs. It is difficult for the binary heterojunction films to realize the effective wide spectrum utilization of solar energy. Ternary strategy, which consists of one donor and two acceptors or two donors and one acceptor in a bulk-heterojunction, has proven to be an effective and facile way to enhance performances of OPVs. The emergence of new NFAs such as ITIC, IT-4F, Y6 etc. greatly increases the selectivity of acceptors in a ternary system. It is necessary to investigate the compatibility of latest NFA materials and corresponding ternary device performance. In this article, we report a new ternary OPV system with dual NFAs and a polymer donor. The excellent NFA material (Y6), which was first reported in 2019, is used as the third component. Different concentrations of Y6 are introduced into the binary system based on PBDB-T-2F:IT-4F. The compatibility between materials and device performances are investigated through absorption capability of blend films, AFM, water contact angle, GISAXS, and corresponding electrical properties of devices. The 12.48% PCE is achieved from ternary OPVs with PBDB-T:IT-4F as the active layers containing 20wt% Y6 in acceptors, resulting from the enhanced Jsc of 22.09 mA/cm2, Voc of 0.83 V and FF of 68.45%. The origin of the improvement of the ternary OPVs is summarized below. Firstly, an apparently complementary absorption spectrum is obtained through the introduction of Y6, which has a stronger photo harvesting capability in the spectral range from 750 to 950 nm than IT-4F, and higher short current density (Jsc) is observed in the ternary devices than in the binary device. Secondly, a rougher surface of the active layer is observed by increasing the Y6 concentration, which may result in an inferior exciton dissociation and charge transport process, the existence of larger-scaled crystal is proved by the GISAXS technology. Thirdly, the introduced Y6 can help to suppress the bimolecular recombination, which is in favor of the incremental device performance. Approximately 17.85% PCE improvement is obtained in comparison with PBDB-T-2F:IT-4F based binary OPVs.

Efficient Ternary Indoor Organic Photovoltaics with Fullerene Derivative as the Host Acceptor and Nonfullerene Material as the Guest Acceptor

Contrastive Manipulations on Vertical Stratifications by a Fluorescent Guest Component in Ternary Nonfullerene and Fullerene Organic Solar Cells

Highly Efficient Ternary Solar Cells with Efficient Förster Resonance Energy Transfer for Simultaneously Enhanced Photovoltaic Parameters

Guest-oriented non-fullerene acceptors for ternary organic solar cells with over 16.0% and 22.7% efficiencies under one-sun and indoor light

A Trialkylsilylthienyl Chain-Substituted Small-Molecule Acceptor with Higher LUMO Level and Reduced Band Gap for Over 16% Efficiency Fullerene-Free Ternary Solar Cells

Boosting Photovoltaic Performance of Ternary Organic Solar Cells by Integrating a Multi-Functional Guest Acceptor

Fullerene as an additive for increasing the efficiency of organic solar cells to more than 17%

Efficient Ternary Organic Solar Cells Enabled by the Integration of Nonfullerene and Fullerene Acceptors with a Broad Composition Tolerance

Ternary blend strategy in benzotriazole-based organic photovoltaics for indoor application

Enhanced Photovoltaic Performance of Ternary Polymer Solar Cells by Incorporation of a Narrow-Bandgap Nonfullerene Acceptor

Multiple Roles of a Non-fullerene Acceptor Contribute Synergistically for High-Efficiency Ternary Organic Photovoltaics

High-Performance Ternary Organic Solar Cells through Incorporation of a Series of A 2 -A 1 -D-A 1 -A 2 Type Nonfullerene Acceptors with Different Terminal Groups

Ternary‐organic Photovoltaics with J71 As Donor and Two Compatible Nonfullerene Acceptors

Using fullerene as the third component to boosting the photovoltaic performances of pyran acceptor

Highly Efficient Parallel-Like Ternary Organic Solar Cells

16.7%-efficiency ternary blended organic photovoltaic cells with PCBM as the acceptor additive to increase the open-circuit voltage and phase purity

Dual Non-Fullerene Acceptors Based High Efficiency Ternary Organic Solar Cells

Efficient Ternary Organic Photovoltaic Device with Non-halogen Solvent via Synergistic Inhibiting Charge Recombination and Regulating Morphology

From Binary to Ternary: Improving the External Quantum Efficiency of Small‐Molecule Acceptor‐Based Polymer Solar Cells with a Minute Amount of Fullerene Sensitization

Enhanced Efficiency and Excellent Thermostability in Organic Photovoltaics via Ternary Strategy with Twisted Conjugated Compound

Ternary Organic Blend Approaches for High Photovoltaic Performance in Versatile Applications