Abstract:Patients with a spinal cord injury (SCI) are susceptible to deep tissue injury (DTI), a necrosis in excessively deformed muscle tissue overlying bony prominences, which, in wheelchair users, typically occurs in the gluteus muscles under the ischial tuberosities. Recently, we developed a generic real-time, subject-specific finite element (FE) modeling method to provide monitoring of mechanical conditions in deep tissues deformed between bony prominences and external surfaces. We previously employed this method to study internal tissue loads in plantar tissues of the foot [Yarnitzky, G., Z. Yizhar, and A. Gefen. J. Biomech. 39:2673-2689, 2006] and in muscle flaps of residual limbs in patients who underwent transtibial amputation (Portnoy, S., G. Yarnitzky, Z. Yizhar, A. Kristal, U. Oppenheim, I. Siev-Ner, and A. Gefen. Ann. Biomed. Eng. 35:120-135, 2007). The goal of the present study was to adapt the method to study the time-dependent mechanical stresses in glutei of patients with SCI during wheelchair sitting, continuously in real-time, and to compare the trends of internal tissue load data with those of controls. Prior to human studies, the real-time FE model-adapted to study the buttocks during sitting-was validated by comparing its predictions to data from a physical phantom of a buttocks and to non-real-time, commercial FE software. Next, real-time, subject-specific, FE models were built for six participating subjects (3 patients with SCI, 3 controls) based on their individual anatomies from MRI scans. Subjects were asked to sit normally in a wheelchair, on a ROHO cushion, and to watch a 90 min movie. Continuous interface pressure measurements from a pressure mat were used as subject-specific boundary conditions for real-time FE analyses of deep muscle stresses. Highest peaks of compression, shear and von Mises stresses throughout the trial period, and averages of peaks of these stresses were recorded over the trial for each individual. These parameters generally had 3-times to 5-times greater values in patients with SCI compared with controls. Likewise, stress doses, defined as the integration of peak compression stress over time, were approximately 35-times and approximately 50-times greater in the subjects with SCI, the values referring to the highest of all peaks recorded throughout the trial, and to average of peaks over the trial, respectively. We believe that by allowing-for the first time-practical and continuous monitoring of internal tissue loads in patients with motosensory deficits, without any risk or interruption to their lifestyle, and either at the clinical setting or at home, the present method can make a substantial contribution to the prevention of severe pressure ulcers and DTI.

Shear stress measured on beds and wheelchairs

An apparatus to quantify anteroposterior and mediolateral shear reduction in shoe insoles.

Real-time finite element monitoring of sub-dermal tissue stresses in individuals with spinal cord injury: toward prevention of pressure ulcers

Validating a wheelchair in-seat activity tracker

MR-compatible loading device for assessment of heel pad internal tissue displacements under shearing load

Wireless, multimodal sensors for continuous measurement of pressure, temperature, and hydration of patients in wheelchair

A Novel Elastic Sensor Sheet for Pressure Injury Monitoring: Design, Integration, and Performance Analysis

Modern developments in shear-stress measurement

Smart Cushions with Machine Learning-Enhanced Force Sensors for Pressure Injury Risk Assessment

In-shoe plantar shear stress sensor design, calibration and evaluation for the diabetic foot

Bone Geometry on the Contact Stress in the Shoulder for Evaluation of Pressure Ulcers: Finite Element Modeling and Experimental Validation.

The relationship between torso inclination and the shearing force of the buttocks while seated in a wheelchair: Preliminary research in non-disabled individuals

Microscopic contact area and friction between medical textiles and skin

Sitting Pressure Measurements in Wheelchair Users—Can the Effects of Daily Relief Activities Be Depicted?

Risk factors for developing heel ulcers for bedridden patients: A finite element study

MR-based quantitative measurement of human soft tissue internal strains for pressure ulcer prevention

Hygro-thermo-mechanical performance of wheelchair cushion technologies in the prevention of pressure ulcers and moisture-associated skin damages

Development of low-cost pressure mapping device to evaluate force distribution for seat cushion modification

Lateral pressure equalisation as a principle for designing support surfaces to prevent deep tissue pressure ulcers

Use of a Shear Reduction Surface for Prehospital Transport: A Randomized Crossover Study

A Soft Pressure Sensor Skin to Predict Contact Pressure Limit Under Hand Orthosis