Abstract:Wheel-rail force identification is an important inverse problem for structural health monitoring of high-speed railway train-track-bridge system. It is widely used for dynamic response recon-struction of bridges and early safety warning of dynamic reduction rate of wheel weight for the train. It can also serve as a reference for the calibration of wheel-rail force model. This paper proposes a wheel-rail force identification method for high-speed railway based on a modified weighted l1-norm regularization. Based on numerical simulations, it is found that variations of dynamic component of wheel-rail forces are very small. Therefore, the problem is transformed into the identification of three categories of static wheel weights and two categories of average dynamic components, which greatly simplifies the degree of freedom of the solution compared to traditional methods, thereby improving the solution accuracy and saving the number of sensors needed. The wheel-rail forces are decomposed into the product of a series of redundant basis functions and corresponding coefficients. The fast iterative shrinkage threshold algorithm (FISTA) and the Bayesian information criterion (BIC) are used to seek the solution of l1-norm regulari-zation and to select the optimal regularization coefficients, respectively. Since the number of sensors and their locations have a significant impact on the accuracy of reconstructed wheel-rail forces, they are optimized using a genetic algorithm (GA), aiming to accurately reconstruct the wheel-rail forces with the minimum number of sensors at corresponding optimal positions. Nu-merical simulation of a 32 m box girder standard beam for high-speed railway shows that the reconstructed wheel-rail forces are in good agreement with the simulated results, which verifies the accuracy of the proposed method. In addition, the results of dynamic load test indirectly demonstrate the effectiveness of the proposed method.

DFFRLS-FAUKF: Accurate and reliable monorail longitudinal slope identification method

Data-driven dynamic inclination angle estimation of monorail crane under complex road conditions

Differential Settlement of Track Foundations Identification Based on GRU Neural Network.

A Long-focus Camera and Telemetry LiDAR Calibration for Rapid Transit Equipment.

High-speed Railway Track Regularity Data Fusion Algorithm Based on Kalman Filter and Kalman-RTS Smoother

Track geometry estimation from vehicle–body acceleration for high-speed railway using deep learning technique

Diagnosis of high‐speed railway ballastless track arching based on unsupervised learning framework

AI-based technology to prognose and diagnose complex crack characteristics of railway concrete sleepers

Railway Slope Monitoring Based on Dual-Parameter FBG Sensor

Adaptive Iterative Learning Kalman Consensus Filtering for High-Speed Train Identification and Estimation

A Real-Time Method for Railway Track Detection and 3D Fitting Based on Camera and LiDAR Fusion Sensing

Research on Dynamic Detection of Geometric Parameters of Groove Rail Based on Laser Triangulation and Four-Point Chord Measurement

Wheel-rail force identification for high-speed railway based on a modified weighted l1-norm regularization with optimal strain sensors

FS-RSDD: Few-Shot Rail Surface Defect Detection with Prototype Learning

A Multi-Modal Approach to Rail Surface Condition Analysis: the MFDF-Net

Freight train speed active disturbance rejection tracking and wheel anti-slip based on fuzzy neural network with DBO optimization

Identification of track irregularities with the multi-sensor acceleration measurements of vehicle dynamic responses

FRVO-Mono: Feature-Based Railway Visual Odometry With Monocular Camera

Multisensor Fusion for Railway Irregularity Inspection System: Integration of RTK GNSS, MEMS IMU, Odometer, and Laser

Urban rail track condition monitoring based on in-service vehicle acceleration measurements

A Fuzzy Adaptive Reasoning Method for Trains Slide/slip Detection