Abstract:Elastic materials include metal plates, rubber, foam, airbags and so on, which have a good buffer effect, toughness and strong recovery ability. In this paper, the deformation and thermal diffusion of 2D and 3D thin plates are studied. Two models are established for the deformation of 2D thin plates. The bending deformation equation of rectangular and circular plates is derived, and the semi-analytical solution of the deflection function w(x,y) is found through the Fourier series approximation in the polar coordinate. The consistencies of the numerical solution and the theoretical solution are verified by numerical method. Then, we find that the factors affecting the deformation are related to the Young's modulus, load, plate length and deformation factor α of the material. In a separate temperature physics field, we establish a heat conduction model of 2D graphene film. Three numerical schemes of the transient heat conduction equation of FDM-FEM are given. In contrast, this paper uses the implicit Euler method to discrete the time term. Furthermore, we compared the difference between the adiabatic condition and the convection condition by the graphical method and the curve trend. The results show that the temperature near the adiabatic boundary is higher. Finally, we proposed a 3D dynamic thermal-mechanical coupling model (3D-DTMCM) that has been established. A laser heating monocrystalline silicon sheet with periodic motion formula is given. The temperature radiation of the laser heat source has Gaussian distribution characteristics. Our proposed model can dynamically determine Young's modulus with a variable temperature. The numerical results show that the higher the temperature is, the higher the strain energy density of the plate is. In addition, the deformation amplitude of the plates in the coupling field is larger than that in the single mechanical field. Finally, we also discussed the stress field distribution of mixed cracks under high temperature and high load. Our research provides theoretical support for the deformation of different plates, and also reflects the value of the coupled model in practical applications.

Three-dimensional finite discrete element-based contact heat transfer model considering thermal cracking in continuous–discontinuous media

A new 3D continuous-discontinuous heat conduction model and coupled thermomechanical model for simulating the thermal cracking of brittle materials

A three‐dimensional heat transfer and thermal cracking model considering the effect of cracks on heat transfer

A coupled contact heat transfer and thermal cracking model for discontinuous and granular media

A new 2D continuous-discontinuous heat conduction model for modeling heat transfer and thermal cracking in quasi-brittle materials

A 2D discrete heat transfer model considering the thermal resistance effect of fractures for simulating the thermal cracking of brittle materials

Simulation of heat conduction and thermal cracking of brittle materials using the particle-based discontinuous deformation analysis

Modeling of heat transfer and thermal cracking in brittle materials using Finite-Discrete Element Method (FDEM) with a heat pipe model and node binding scheme

A new thermomechanical coupled FDEM model for geomaterials considering continuum-discontinuum transitions

A three-dimensional thermal-hydro-mechanical coupling model for simulation of fracturing driven by multiphysics

A composite element solution of convection-conduction heat transfer in fractured rock mass

Transient response of interface crack-containing plates during non-Fourier heat conduction processes based on peridynamic Green-Naghdi-III model

Thermal-mechanical coupling smooth particle hydrodynamics-phase field method modelling of cracking in rocks

A FDEM-based 2D coupled thermal-hydro-mechanical model for multiphysical simulation of rock fracturing

Linear-frictional contact model for 3D discrete element simulations of granular systems

A non-local heat transport model in solids with discontinuities via Lagrangian particle method

A thermo-mechanical phase-field fracture model: application to hot cracking simulations in additive manufacturing

A Three-Dimensional Grouting Model Considering Hydromechanical Coupling Based on the Combined Finite-Discrete Element Method

A Dynamic Thermal-Mechanical Coupling Numerical Model to Solve the Deformation and Thermal Diffusion of Plates

A Peridynamic Model for Contact Problems Involving Fracture

A Contact Force Model for the Dynamic Response of Cracks