Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Effect of pressure on the electronic structure of hcp Titanium

Theoretical Investigation of the High Pressure Structure, Lattice Dynamics, Phase Transition, and Thermal Equation of State of Titanium Metal

Pressure-Induced Reversible Hcp to Fcc Phase Transition of Ti: A First-Principles Study

Anisotropy in Elasticity and Physical Properties of Ti2B under High Pressure

Density functional theory study of the α --> ω martensitic transformation in titanium induced by hydrostatic pressure

First-Principles Study of High-Pressure Behavior of Solid β-HMX

Ab Initioand Molecular Dynamics Studies of Solid Β-Hmx: Effects of Hydrostatic Pressure and High Temperature

The Structural, Mechanical and Thermodynamic Properties of Ti-B Compounds under the Influence of Temperature and Pressure: First-principles Study

Pressure Effect on Elastic Constants and Related Properties of Ti3Al Intermetallic Compound: A First-Principles Study

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Thermal Equations of State for Titanium Obtained by High Pressure—temperature Diffraction Studies

Physical properties and Debye temperature of Al7Cu2Fe alloy under various pressures analyzed by first-principles

Elastic properties of TiS2 material at high pressure by a first-principles DFT approach

The structure, elastic and thermodynamic properties of Ti2GaC from first-principles calculation

Pressure Dependence of Electron Density Distribution and D-P-π Hybridization in Titanate Perovskite Ferroelectrics

Comparison of mechanical and thermodynamic properties of fcc and bcc titanium under high pressure

Pressure‐induced phase transition and elastic properties of TiO2 polymorphs

Effect of hydrostatic pressure on electronic, elastic, and optical properties of hexagonal lanthanum oxide (La 2 O 3 ): A first principles calculations

Effect of Hexagonality on the Pressure-Dependent Lattice Dynamics of 4H-Sic

Effect of Pressure on Crystal Structure and Lattice Parameters of Iron Up to 300 Kbar

Pressure-induced alpha-to-omega transition in titanium metal: A systematic study of the effects of uniaxial stress