Abstract:The design of acoustic liners with complex cavities for a wide frequency range of attenuation using numerical method is investigated in this paper. Three novel liner concepts are presented, demonstrating predicted improvements in broadband sound absorption when compared with that for conventional designs. The liners include a slanted septum core, a slanted septum core with varying percentage open area, and a MultiFOCAL concept. A finite element model of a normal incidence impedance tube is developed using COMSOL Multiphysics modeling software to predict the acoustic properties (resistance and reactance) of liners at medium and high sound pressure levels, and to study the impact of variations in the liner design parameters. The impedance tube finite element model incorporates non-linear semi-empirical impedance equations, validated by comparing numerical results with measurements performed on a single-degree-of-freedom liner, with a perforated face sheet, at high sound pressure level. The design variables of the novel liner concepts are optimized using a hybrid automated optimisation procedure. The low-frequency optimum slanted septum core concept with an open area of 4.5% for the face sheet and 18% for the short slanted septum is predicted to have an absorption level of at least 14 dB in the frequency range of 400–1000 Hz for normally incident pure tone excitations at 150 dB. The slanted septum core concept with varying percentage open area, with broadband optimum design variables, is predicted to have good broadband sound absorption levels of at least 10 dB in the frequency range of 570–3800 Hz. Finally, the MultiFOCAL liner concept with optimised percentage open areas is predicted to have an excellent broadband sound absorption levels of at least 14 dB, for pure tone excitations at 150 dB, in the frequency range of 900–5300 Hz. This work will be followed by optimisation of the face sheet geometries of these novel liner designs in order to maximise lined duct attenuation for aircraft engine applications.

Optimizing acoustic liner conditions for noise control: A study of flexible components and restraint conditions

Slanted septum and multiple folded cavity liners for broadband sound absorption

Analyzing the impact of flexible shells and sound absorbent lining on acoustic wave behavior in ducts

Design and Optimization of 3D Folded-Core Acoustic Liners for Enhanced Low-Frequency Performance

Acoustic modelling and analyses of geometrically complex systems with Micro-perforated panels

A mode-matching analysis of flexible shells and waveguides with partitioning and muffler conditions

Optimality analysis of bulk-reacting liners based on mode-merging design method

Passive acoustic liners for aero-engine noise control: A review

On the application of acoustic liners for the reduction of jet-flap installation noise

Optimizing the noise control in a two-layer conduit

Low frequency and broadband sound attenuation by meta-liner under grazing flow and high sound intensity

Enhanced micro-perforated wall-treatments for reducing the boundary layer noise in a low-speed wind-tunnel: modelling, characterization and optimization studies.

On the noise reduction mechanisms of over-tip liners

Causally-guided acoustic optimization of single-layer rigidly-backed micro-perforated partitions: Theory

Broadband acoustic meta-liner with metal foam approaching causality-governed minimal thickness

On enhancing the noise-reduction performance of the acoustic lined duct utilizing the phase-modulating metasurface

Improving sound insulation near ring and coincidence frequencies of cylindrical sandwich shells

Deep cavity noise suppression by exploiting aeroacoustic–structural interaction of multiple elastic panels

Double Degree of Freedom Helmholtz Resonator Based Acoustic Liners

Acoustic Liners Combined with Fine Perforated Film

Physics-Informed Acoustic Liner Optimization: Balancing Drag and Noise